EIGRP Over Frame-Relay Hub-And-Spoke

In this video we are going to configure EIGRP on a hub-and-spoke frame-relay network and talk about one of the biggest traps students run into with this particular technology -- and of course how to get around it : )

[@pikachoooooooooooooo]

Excellent. Thanks

[@AmerikkkaGuitars]

great vid, thanks it really clarified things

[@MrBrijeshbhatt253511]

Its Ok and understandable.... spokes are able to reach each other from loopback.. but not able from router.... what could be the cause... plz clear.. thanks in advance.

[@Ronnie9P]

i don't understand, why is then advisable to use subinterfaces in these cases ?

[@juliane.freteiommi6745]

you are big man.....kind regards from argentina

[@williebrown4266]

Very good video.

[@steinmil]

so just use p2p subinterfaces sure you loose ip addresses but at least you can still have split horizion enabled

[@ashse6791]

good to know:
no ip split-horizon eigrp xxx
this command requires eigrp xxx to be mentioned else sh ip int s1/0 shows you Split Horizon is disabled but even then doesn't work until we specify eigrp xxx.
Thanks Joe, its my new learning