I rebuilt a HP300 last week. I just heated the socket with a rose bud and set it straight on, and able to set the socket liner on straight afterwards with no extra heating
Was soll das sein ?? Ich habe früher ehemals Omnicone 937, 1144,1356 HP 400 und 500 etc. die Tragschale allein bei 120-130 °C aufgebaut und geschrumpft. Danach aufgesetzt mit Gummihammer festgeschlagen und gleich die Bolzen eingesetzt und verschraubt mit Schlagschrauber, danach sofort das Bronzelager aufsetzen und verschrauben. Das Schrumpfmaß liegt bei 0,1-0,2mm. Da benötigt man keine 170°C. Würde sagen nicht aufgepasst bei Schulungen in Macon ehem. Bergeaut - Nordberg oder Tampere - Nordberg !!!
@@isaacmensah7154 the main shaft can be pressed out with press, it is tight interference fit of 15/1000 inch, (0.015 inch) the shaft is tapered fit, when you want to install it, heat the frame to 250 Degrees Celsius
I rebuilt a HP300 last week. I just heated the socket with a rose bud and set it straight on, and able to set the socket liner on straight afterwards with no extra heating
Gladly, I am the factory that produces HP300 parts.
Nice video. May i asking. Why Nordberg HP300 Cone machine was trip (electric) when to operate? its caused by countershaft and eccentric bushing?
I'm very knowledgeable about Metso equipment technology, or I can answer for you
Was soll das sein ?? Ich habe früher ehemals Omnicone 937, 1144,1356 HP 400 und 500 etc. die Tragschale allein bei 120-130 °C aufgebaut und geschrumpft. Danach aufgesetzt mit Gummihammer festgeschlagen und gleich die Bolzen eingesetzt und verschraubt mit Schlagschrauber, danach sofort das Bronzelager aufsetzen und verschrauben. Das Schrumpfmaß liegt bei 0,1-0,2mm. Da benötigt man keine 170°C. Würde sagen nicht aufgepasst bei Schulungen in Macon ehem. Bergeaut - Nordberg oder Tampere - Nordberg !!!
Get a hotter torch
Why
@@mahmudalisakah4024 can warm it quicker
No, the part become blue with high heat
Want to remove metso HP400 mainshaft please can you send me the procedure please
@@isaacmensah7154 the main shaft can be pressed out with press, it is tight interference fit of 15/1000 inch, (0.015 inch) the shaft is tapered fit, when you want to install it, heat the frame to 250 Degrees Celsius