How To Install The Graco® Turn2Me™ 3-in-1 Car Seat Rear-Facing using the Vehicle Seat Belt

#convertiblecarseat #carseatinstallation #bestinfantcarseat
Learn how to install the Graco Turn2Me 3-in-1 Rotating Car Seat rear-facing using the vehicle seat belt by following these easy steps. The Graco® Turn2Me™ rotates from rear-facing for a face-to-face connection with baby to get them in and out of the car with ease! Before learning how to install your baby car seat with seatbelt at the back seat, you will need to know how to use the car seats’ turn feature. The turn levers are located under each armrest, but you only need to use one to turn the seat. At the same time, squeeze the blue trigger and the grey lever and rotate the car seat. After rotating your infant car seat into the rear facing position, you will know your seat is secure in position after hearing a click.
Rotate the 3-in-1 car seat into the rear-facing position. Next, recline the car seat into one of its four positions using the actuator. Now place the car seat in the back seat of your vehicle. After making sure your level indicator is in rear facing, remove the infant body support. Open the car seat door by pressing the grey button at the front of the seat. Open the SnugLock lock off with the grey lever. Route the vehicle seatbelt through the rear-facing belt path. After buckling the seatbelt, remove slack then close the SnugLock lock off. Check for tightness along the rear facing belt path and adjust harness at perfect height for your little one using the baby car seat belt adjustor. You are now finished with car seat installation for the Graco Turn2Me 3-in-1 Car Seat.
Want to learn more about the Graco Turn2Me 3-in-1 Car Seat? Visit us: www.gracobaby....
Want to learn about Graco’s car seat safety standards? Visit us: www.gracobaby....
#carseatinstallation #convertiblecarseat #bestinfantcarseat #gracocarseat