Dude totally jacked the "hopper support rod!" You should share that this was an error, so others realize it as improper installation and keep them from frustration later when their rods fall out
This instruction guide was so instrumental in making assembly so easy. However please note, there have been some great improvements on some hardware parts since the making of this video, Keep up the good work
A very needed and helpful video. My unit did NOT have any red marking on the brushes as shown. Only a black marking on one of the brushes. There were no rubber plugs as listed but additional clevis pins for fasteners. Labeling the tubes would be a welcome addition to better differentiate the bag tubes.using only paper instructions is difficult but used with this video is helpful.
Everything was going great until the point 14:07, referencing "part Z". We stopped to look for a plastic plug. Nothing. Then referred to the parts list. There is no part Z. So we then turned to the photo instructions and found the part is actually "P". Otherwise great video.
Great detailed video! Thanks for sharing. It would have taken me a lot longer to assemble my sweeper without this video!👍🏾👍🏾
Dude totally jacked the "hopper support rod!" You should share that this was an error, so others realize it as improper installation and keep them from frustration later when their rods fall out
This instruction guide was so instrumental in making assembly so easy. However please note, there have been some great improvements on some hardware parts since the making of this video, Keep up the good work
Thanks ! Very informative.
A very needed and helpful video. My unit did NOT have any red marking on the brushes as shown. Only a black marking on one of the brushes. There were no rubber plugs as listed but additional clevis pins for fasteners. Labeling the tubes would be a welcome addition to better differentiate the bag tubes.using only paper instructions is difficult but used with this video is helpful.
my hopper will only fill half way because it doesnt sit flat causing the leaves to gather at the front near the brushes!
Mine too. Let me know if you figure something out! I'm about to cut it off and bend the tube and weld it back 😂
Yes my hardware didn’t have plastic plugs.
So very helpful. The instructions that came with the sweeper was difficult to follow. Needed the video as well.
Favorite
Holy crap what side is right and what is left.
Everything was going great until the point 14:07, referencing "part Z". We stopped to look for a plastic plug. Nothing. Then referred to the parts list. There is no part Z. So we then turned to the photo instructions and found the part is actually "P". Otherwise great video.
My hopper is too high. What did I do wrong?
mine was to lol
Did you ever figure it out?