Размер видео: 1280 X 720853 X 480640 X 360
Показать панель управления
Автовоспроизведение
Автоповтор
You're doing so much for the S2K community -- thank you.
Once again the best DIY s2000 content out there. You are appreciated
Finally! About to replace the rear wheel hubs and bearings on my CR too, perfect timing.
Thank you from Spain.Today I made it.We put Lbs torque spindle nut 300nm, (Honda says 250 rear and 320 front wheel)Abs sensor is too fragile, now the abs check light is on. I have to look That now.Have a nice day and enjoy your S2k
Hand Brake + 6th gear is all the resistance you need, works for the crank pulley too ;)
Oh true I never thought about that. I'll try that instead next time - thanks
Legend! Thanks from across the pond!
Yes!! I needed this!! My rear ball joints are in need of replacement.
That’s coming up after this series
Thank you I just smashed into a curb and messed everything up. Going to look at it tomorrow
Great video like every video. Very underrated channel. I wish you 100.000 views per day. :) Greetings from Germany.
I was just searching for this video! Great timing! Thanks!
Damn I needed this a few months ago. Was a lame job lol
Waiting on the bearing and hub part 😊
I finished filming it this past weekend. Just gotta stop being lazy after work and edit it :)
Hey friend. Quick question, for the spare hex nut, is that a fine or extra fine thread? Thanks
1.25 is the thread pitch, dunno what that would be classified as
Where the link for the kit that comes with the sleeves ? Tool rental ?
That's an off the shelf front wheel bearing press kit, might be able to rent it.
Hope you didn’t scratch that Apple Watch, pulling the axle assembly!!!
Hope you didn’t scratch your Apple Watch, pulling that axle assembly!!
You're doing so much for the S2K community -- thank you.
Once again the best DIY s2000 content out there. You are appreciated
Finally! About to replace the rear wheel hubs and bearings on my CR too, perfect timing.
Thank you from Spain.
Today I made it.
We put
Lbs torque spindle nut 300nm, (Honda says 250 rear and 320 front wheel)
Abs sensor is too fragile, now the abs check light is on. I have to look That now.
Have a nice day and enjoy your S2k
Hand Brake + 6th gear is all the resistance you need, works for the crank pulley too ;)
Oh true I never thought about that. I'll try that instead next time - thanks
Legend! Thanks from across the pond!
Yes!! I needed this!! My rear ball joints are in need of replacement.
That’s coming up after this series
Thank you I just smashed into a curb and messed everything up. Going to look at it tomorrow
Great video like every video.
Very underrated channel. I wish you 100.000 views per day. :)
Greetings from Germany.
I was just searching for this video! Great timing! Thanks!
Damn I needed this a few months ago. Was a lame job lol
Waiting on the bearing and hub part 😊
I finished filming it this past weekend. Just gotta stop being lazy after work and edit it :)
Hey friend. Quick question, for the spare hex nut, is that a fine or extra fine thread? Thanks
1.25 is the thread pitch, dunno what that would be classified as
Where the link for the kit that comes with the sleeves ? Tool rental ?
That's an off the shelf front wheel bearing press kit, might be able to rent it.
Hope you didn’t scratch that Apple Watch, pulling the axle assembly!!!
Hope you didn’t scratch your Apple Watch, pulling that axle assembly!!