Be Quiet! Dark Power 13 ATX 3.0 PSU Unboxing and Overview
HTML-код
- Опубликовано: 5 окт 2024
- Check out the all new Dark Power 13 ATX 3.0 PC Power Supplies from Be Quiet! There's currently three Dark Power 13 models including 750W, 850W, and 1000W. In this video I open up a brand new 850W PSU, take a close look at the unit and cables, and talk about its main features.
Shop PC Power Supplies on Amazon: amzn.to/3LizlwH
Dark Power 13 Features & Specifications
80 PLUS Titanium certification
ATX 3.0 compliant
PCIe 5.0 (600W) for high-end GPU's
Standby drain of less than 0.1 Watts
Zero-Load design that supports Intel’s Deep Power Down C6 and C7 modes
LLC, Synchronous Rectifier (SR) and DC-to-DC power conversion circuitry
Overclocking key allows you to choose between multi-rail operation with 4 independent 12V rails and high-performance single-rail operation
Premium-quality Japanese capacitors rated at 105°C
Increased output of 12V capacitors to minimize feedback sounds of graphics cards
10-year manufacturer's warranty
Available in 750W, 850W, 1000W
Dimensions without cable (L x W x H), 175 x 150 x 86 (mm)
RRP (USD): $209.90 (750W), $249.90 (850W), $289.90 (1000W)
Website: www.bequiet.co...
This video was shot on:
Sony FX3: amzn.to/3TbFn3Z
Sony FX30: amzn.to/4017UeR
Purchasing links are affiliated. If you click on them and make a purchase, the channel may earn a small commission. It doesn't cost you anything, and helps support the channel. Thank you for your support!
FULL DISCLOSURE: The product featured in this video was provided free of charge by the manufacturer. The opinions expressed in the video are my own and were not influenced by any outside party. 
Наука
Thanks for taking a close look at the SATA cables to break each one down. It's quite important for people with many connections, and drives, to know the layout of cables. 🍻
Dark Power PSUs have only one problem - noise of the fan (internal mechanism), when it is under the load you can't hear it, but if it is in idle mode - t bearing noise can be heard, tried 3 different samples, this 'feature' is going from 12 series.
It's not only you, we all had to deal with this faulty unit. When I called the webshop to return the unit, first question they asked me is that because of fan noise? Yes we know most people are returning them for the same issue.
All over youtube and IG and Reddit people are complaining about this issue and yet BeQuiet is ignoring it. No price drop whatsoever.
Get The Asus one or more of FPS. MSI new model is also good alternative. At least you can sleep in your room while PC is on. No ERRR ErrrrErrrrrr
damn the cage looks so awesome !
Mine has always been silent
Use headphones and stop whining 😄
Fan in upward position mount had zero noise
Thanks for talking about the cables, other RUclipsrs just babbled around and never bothered to talk about the included cables.
Be Quiet!'s Silent Wings 3 fans use a fluid dynamic bearing that is very quiet under load, but at low RPM signal they tend to stutter and click. Just a quirk of the bearing as is needs RPM to generate the fluid vortex that supports the shaft. This product runs the fans too low to stop this clicking behavior. It always "lugs" the fan at idle. Very poor tuning.
i like it, i just dont understand why it would be quad rail when single is better overall.
No coil whining
@@Rayu25Demon shouldn't be coil whining even if single rail, I've got a 1000w seasonic gx and it has single rail, runs perfectly. The dark 13 seems to also suffer from a crappy fan resonance that's why majority of the D13 units are out of stock/ not available again. Seems like everyone has been returning them
@Zombie dude, it's "Seasonic" the best PSU brand.
There's no comparison.
@@Rayu25Demon I'd say bequiet are up there too. But yes I went with seasonic as they never let me down
@@Zombie101 The SL3 fans have amazing bearings for longevity and silent operation...under load. I have a bunch. A few are worse than others at idle when the RPM signal gets too "low" for the fan's fluid bearing and they start to chirp and chatter. FDB fans have a safe minimum speed to keep the fluid vortex going and not rub, but some SL3 fans can run below this and act poorly. Probably the case here. The fan tuning needs a tweak to run at a slightly higher RPM at idle or turn OFF like everyone else.
I like be quiet but the 13 series is really bad. Only the 850W is quiet. Others are not. And the fans are always on... Other PSU-s turn off the fans under low wattages... (cybenetics is a good wepage to check which PSU is quiet which is not)
You say this but the Dark Power 13 1000w is A+ on Cybenetics for noise? There aren't many better.
Good FSP platform and worst cords + worst fan silence :D it's all what we must know :) Be Quiet without quiet :)
1000w is not enough
There is dark power pro 13 1300w and 1600w
It's enough for your poor build especially your consoles Lmaooooo 🤡
great video!
Thanks!
Can it run a rtx 3080ti
Should I use the 600wats pci connector?
An essential tremor?
135mm is VERY common when it comes to psu’s lol. Dk wtf ur point was there buddy.
There is a Pro version correct? So this isn't the pro version right?
Correct. This is the non pro.
The pro version is the 1600W one, with support for two Gpus
My system is 750w do u guys recommend 1000w or more?
850-1000w is fine
This is a premium psu with atx 3.0, then why is it not atx 3.0 certified?
Are they afraid they will be outed for having a noisy fan even at idle? Or that it doesn't meet the power handling requirements for the atx 3.0 standard?
The reason I disliked this video. Please dont help them to sell a faulty power supply. Your subscribers deserve better.
Thanks for the vide, But it could be nice if you mentioned the fan noise issue that everyone is complaining about! This design is buggy and BeQuiet unfortunately doesn't address it. NoQuiet Darkpower 13 850W would fit these models better.
750w is practically silent