Hi, I have a problem with this item. All seems to be working ok except for I can't change the relay close time! Ive tried everything following the instructions given, even trying the reset, but it still wont change the close time. I keep getting message 'Command error, re-send command Please' Can you please advise if there is anything else I can do or is this a faulty item that needs replacing. Thanks
Where is the imei number located on this model. I purchased one and trying to set up a mint mobile sim card. Its asking me the imie number for the device. Have no clue to where its located. Any help would be appreciated
Hi there. My rtu5024 works fine for a day or two but then requires a power reset to operate again. It's very frustrating. Does anyone know why this is happening? I am using a brand new sim card with a strong signal with line of sight to nearest mast.
@@Imkerei2024 you can't, the gsm only send one signal and that signal stay up for a period of time that you can set, you can only delay the switch off signal by sms code (PASSGOT0NUM# if your pass is 1234 and 10 seconds it's 1234GOT010#), so to off that signal you need to call again, or just put 0 second off. I was thinking to use another relay that send two signals so you can change it by sms the close it time, with that you need to put the gate to manual open and close so the gsm will do it at the end we just installed a infrared sensor.
Markus, since you've been able to make this work we have a question for you. When sim card is in a phone, call goes through to phone. When sim card is in RTU5024, calls go directly to voicemail and does not trigger switch. Any suggestions?
شرح جميل جداًّ ومفصل. شكراً لكم.
do you need to pay a monthly fee for the use of a sim card in this?
Türkiye'de bir seneden fazla kullanabiliyormuyuz
Sir
Very good, where i can buy, im from Portugal
אהבתי את השנאי של הוט ;) אבל בטאכלס איך המוצר ? אמין? הפתיחה מתבצעת ע'י שיחה או באפליקציה?
Verbal instructions instead of annoying music would be helpful.
Would be nice if you could translate to English - please. Perhaps show everything you are doing.
Hi, I have a problem with this item. All seems to be working ok except for I can't change the relay close time! Ive tried everything following the instructions given, even trying the reset, but it still wont change the close time. I keep getting message 'Command error, re-send command Please'
Can you please advise if there is anything else I can do or is this a faulty item that needs replacing.
Thanks
Aunque soy de Chile te pude entender gracias
Where is the imei number located on this model. I purchased one and trying to set up a mint mobile sim card. Its asking me the imie number for the device. Have no clue to where its located. Any help would be appreciated
How you open that door ? Its possible to open and close ?
You go trough a magician course first
يمكنه التحكم بمضخة ماء من بعد؟
Hi there.
My rtu5024 works fine for a day or two but then requires a power reset to operate again. It's very frustrating.
Does anyone know why this is happening?
I am using a brand new sim card with a strong signal with line of sight to nearest mast.
Me too same problem
@@robblackmore3952 I sorted this problem out by getting the unit replaced. I'm putting it down to a bad unit.
I haven't had a problem since.
@@donncha0 Thanks for the the reply I've just ordered new one try that
Can we do a reset for the system?
can be possible to connect the normally open really to after a period of time open and close it?
Did you find way how open and close
@@Imkerei2024 you can't, the gsm only send one signal and that signal stay up for a period of time that you can set, you can only delay the switch off signal by sms code (PASSGOT0NUM# if your pass is 1234 and 10 seconds it's 1234GOT010#), so to off that signal you need to call again, or just put 0 second off. I was thinking to use another relay that send two signals so you can change it by sms the close it time, with that you need to put the gate to manual open and close so the gsm will do it at the end we just installed a infrared sensor.
@@Abbathsin can i use this to call and open door , again call to close door , thats all what i need but with gsm and which motor you think i need
I need some smaller motor 12v
@@Imkerei2024 yes you can use it that way, call to open call to close, relay on 0 seconds.
السلام عليكم ممكن اتحكم بمضخة زراعية عن بعد بحيث اتحكم فقط بالاطفاء فقط كون الكهرباء غير مستمره
بتتحكم تقريبا في اي جهاز كهرباي
How and where did you get the sim card?
From your local wireless provider or even walmart. Depends on which carrier you need.
Does anyone know the difference between rtu5025 and rtu5035?
Hi friend. Could you tell me why the date and time schedule for authorized numbers does not work?
Where can I find a SIM card?
Local cellular dealer or even walmart
كم ثمنه بتونس؟
is it applicable also with water pump sir?
Hello
Could you please send your email to contact with you about these devices ? Thanks
My RTU5024 requires a reset about every week. Anybody knows what would be wrong? is RTU5025 working more reliable? Any suggestions?
Hi, I'm looking to buy RTU5024 for big building. How do you mean it requires reset? Does it stop working every week? Thanks in advance.
Mine has just started doing this its about 2years old and now it stops working and needs a reset to get it going again? did you manage to fix your?
Markus, since you've been able to make this work we have a question for you. When sim card is in a phone, call goes through to phone. When sim card is in RTU5024, calls go directly to voicemail and does not trigger switch. Any suggestions?
Jose Perez have you figured anything out on this?I am having the same issue
Jose Perez can you call me 2057176229
If the password for the card is lost, can we retrieve it and how?
How to check its imei number?
Friend how much.
ebay sell them
Here too! Much too often superfluous annoying fucking music instead of instructions!!
Sir new number add please explain