Creality CR-Laser Falcon for RC Aircraft, Laser unboxing, assembly, and multi-material examples.

This laser cutter can be used to cut out balsa ribs, bulkheads, basswood, plywood, an much much more! Scan in your Aircraft planes to cut out 1to1 or scaled balsa components. A must see for any hobbyist that likes to build RC Balsa Aircraft.
Video covers:
* Unboxing and initial setup.
* Laser cutting the initial test peice.
* Laser engraving a logo leather patch.
* Laser cutting a logo stencil.
* Scanning in plans and how to import into Lightburn to cut out a balsa rib for RC Airplane.

[@user-qb5hg2qh2r]

Please purchase honeycomb laser bed. Air will flow through the the cuts instead of causing the material from floating and popping out of the pattern.

[@georgessmokymountainrc5815]

Thanks for the tip

[@igorhlavaty2060]

In my experience, the cut is much more accurate when you use the multi-pass setting. I usually use 2-4 passes. Plus you have to have a honeycomb. And for thin materials, the laser should be set to the highest position. Not the lowest.

[@canalboating]

Hi just learning this myself I think you focused the laser head wrong thin material up to 3mm should be on the highest step of the focusing tool, hope that helps

[@kensanders2617]

Got the grain wrong on that rib
dude

[@georgessmokymountainrc5815]

Yep, that was prof of concept. When I do all the cuts I will get the grain correct. Defiantly will snap if I bend it as it is on that first piece. I needed thicker stock as well. Looking forward to building this plane in the off season over the next few months.

[@Hopatzful]

5w or 10w?

[@georgessmokymountainrc5815]

10 Watt