RCI Rock Slider Installation Toyota Tacoma 3rd Gen Double Cab Long Bed

- This video shows you how to install the RCI Rock Sliders on a 3rd Gen Toyota Tacoma Double Cab Long Bed!
- Don’t forget to follow me on Instagram @SouthEasternTacoma where I post daily!

[@fincherelli73]

Just got mine today thanks for the video

[@shaggybx]

How did you deal with the brake line bolts?
Thanks for the video

[@andysankar4856]

So how’d you get the broken bolt out? Because the same thing just happened to me 😂

[@southeasterntacoma7523]

Damn! Unlucky! I ended up drilling it out. Grab your strongest drill and drill bit and just take it to it. Start small, and then go bigger if you need. Ideally you will not make the factory hole any bigger nor strip the inside. If you can’t do that, just take it into a shop. They can get it done in a few minutes and shouldn’t charge more than $20 for something like this. Sometimes better safe than sorry if you don’t have right equipment or skills. Good luck! It’ll all turn out fine

[@Floki1624]

Anyone who could answer my rookie questions attached to each piece of hardware? I have a 2019 Double Cab Short Bed.... just trying to get a good idea before I dive under this thing...I've seen the other videos so I'm aware of the tacoma parts that are removed before starting...
2 EA. M10 x 1.25 x 30mm Bolts: In step 4 they say to use the M10 to replace the bottom frame bolt we take out but in step 2 they say to use the 'longer' bolt....which I see as the 7/16, 2"
so sort of confused...
3 EA. M8 x 1.25 x 30mm Bolts: ...not sure where these go... they are the skinniest bolts in the package
3 EA. 5/16” Washers: I'm guessing these go with the above M8's?
10 EA. 7/16” x 1.5” Bolts: I am guessing these go on the outsides of the frame? But, where else...
4 EA. 7/16” x 2” Bolts: Unsure about these but they're the longest ones in the box! Guessing some of them help refasten the black box but what about the others?
12 EA. “Half Moon” Backing Plates...mine are FULL circle plates...hoping they don't cause issues
2 EA. Frame Cross-member Backing Plates (with welded nuts) I'm not sure which bolts go with these...?
16 EA. 3/8” Washers (For use with M10 and 7/16” bolts)
12 EA. 7/16” Lock-washers pretty sure rci stated these go on the inside of the frame
12 EA. 7/16” Hex Nuts ... no explanation needed but wondering why only 12... Guessing I'm reusing a bunch of tacoma hardware?

[@alexhurtado4708]

Just got mine yesterday. Did the weight impact your ride height much?

[@southeasterntacoma7523]

No I did not notice a major difference

[@alexhurtado4708]

@@southeasterntacoma7523 thanks for the reply. I didn’t notice a difference either.