Another Walbro HDC Carburetor How To Video, Including Check Valve Work!

[@robertsimard735]

Great tutorial on them check valve.

[@wrayjordan8315]

Another good informative video.
Great info!

[@stevenharmon4863]

Thanks for the demonstration, it was very helpful, I learned a lot.

[@garyintelisano984]

Thanks Leon for another very informative video!

[@hosocat1410]

You are the master!

[@RS-cb7nm]

Great vid!👍

[@TopNotchSawRepair]

Great explanation of how a hdc carb works 👍 I couldn't have said it any better than u did.

[@justinweaver8107]

Merry Christmas sir❤

[@thankswillie]

thanks for explaining the test at the end

[@chainsawcanuck]

Walbro hdc carbs have taken at least 10 years off my life..lol

[@ewoodWood]

A good mechanic needs a good selection of cuss words in his toolbox!!!

[@n.b.p.davenport7066]

Crankshaft seals always were a lot of the problem, I have a solo I forget what size it is Swedish saw still runs today. I cut wood for years and never had much problem with stars I don't know if everybody's difficulty is

[@jimkillen1065]

Had no idea how these carbs functions..Thanks for the information..is there a fuel additive you recommend that can help clean out the fuel system 😊

[@dennisharrison4744]

Iv experience it back in the day didn't realy know they had a check valve even saw shops didn't know

[@garengtutorial8923]

Bagus bos

[@rcf8367]

Thumbs down again for Charlie, compare the two screw HDC-65 against the single screw HDC-15 you rebuilt…both use the “V” 92-198 gasket.
Always check the factory IPL!