X111 CONNECTOR , NOW ALL I NEED IS TO FIND THIS CONNECTOR OR SOMETHING SIMILAR TO THIS ON HONDA AND NISSAN . THANK YOU SIR FOR TAKING TIME OUT TO GIVE US ALL THIS GREAT INFORMATION !
Thanks man, your video just save my life, haha, I had just replace my engine and I could communicate with my PCM because I did not plug the head light. Thanks
Great information Sam, thanks for sharing! The wire harness layout on this engine is a real treat for sure! Dropping these packs is a must when doing heavy engine work and the AWD model is a bit of a painful experience if you are doing them for the first time for sure! Give me a bulk connection GM!
I have an 08 enclave with no crank no start no com amd gas gauge reads E but is full. When key in on position dash lights up perfect then when put to start all dash lights black out headlights go off and nothing until back in on position. Cannot figure it out have replaced starter, alternator, battery, and the engine was jacked up to replace motor mount. Checked all fuse box pins and fuses and relays have been checked and replaced, cleaned up and fixed wires to starter and back grounds.
I changed out that fuse relay instrument panel wiring harness Junction block without disconnecting my battery. And now I have no power. What can cause this?
I just purchased a 2013 Buick Enclave and it is stuck in anti-theft. I took it to the auto electrical shop and they are saying it may be a issue between the BCM or wiring dropping voltage. The last thing that was done to this cat was changed battery cause the old one had a shortage cell and was stinking the car up. Right now it’s not cranking and the anti-theft light stays illuminated. Note this car drove and operated just fine after the battery change but later that night it would not crank. Battery is fully charged and brand new
Did you fix your problem with your theft system on your buick. If not check the smart Junction box for water Intrusion and green crustys . I just worked on one with a few problems and I found that water was getting in through the sunroof and getting in the smart Junction box and I know it controls the theft system
Always interesting and informative. You are an exceptional talent. Thank you for sharing. I found it humorous when you inferred that a 2008 is old. I am still driving OBDIs. Haha.
I'm having a similar issue on a 2012 Enclave and wondering if the repair work I recently had done had an impact on that wiring harness. I had the Water Pump replaced and when I got the vehicle back, the check engine light went on and the car wouldn't start on the first try. The shop check the codes and told me to have a lock smith replace the security key fob. Lock Smith says that wasn't the problem. Take it back to the shop who then tells me it's something on the computer board which is 6 weeks out. I drove it until it finally wouldn't start anymore. The car stalled while driving about 30 mph once during this time. How difficult is it for a layman to figuring out this wiring stuff?
I have a 2008 Buick enclave cx sometimes it won't crank and I play with the switch of and on and it will crank up and sometimes it would crank so I play with the switch
Liked and subscribed. Could this cause the PWR/TRN Relay to click continously around twice per second and still to run, start, crank, or starter click? New fully charged battery, everything else works. Thanks
I have been having issues of interment comm issues on the same year car with the articulating head lights. Also the right headlight does clicker sometimes. I haven't been able to catch it in the act with my scope. Is the headlight module in the headlight assembly itself?
I drive mine for a while then all of a sudden when i start it up it has no juice...i have to play with the battery wiring on the floor and then power comes back eventually....any idea whats the issue sir?...and yes there is something wrong with passenger headlight...i had to wire a ground to the headlight bulb and it worked again...i changed bulb then ballast...then saw the ground issue ...thanks for any feedback.
Seems I need an electric guy, got it to start cranking today, definitely bad ground for me it a power issue. I played with the wires behind fuse box and engine.
What a stupid design. I had the same problem. Just did the timing repair. While the right headlight isn't connected you have no start no communication issue.
X111 CONNECTOR , NOW ALL I NEED IS TO FIND THIS CONNECTOR OR SOMETHING SIMILAR TO THIS ON HONDA AND NISSAN . THANK YOU SIR FOR TAKING TIME OUT TO GIVE US ALL THIS GREAT INFORMATION !
Thanks man, your video just save my life, haha, I had just replace my engine and I could communicate with my PCM because I did not plug the head light. Thanks
Glad it helped
Great information Sam, thanks for sharing! The wire harness layout on this engine is a real treat for sure!
Dropping these packs is a must when doing heavy engine work and the AWD model is a bit of a painful experience if you are doing them for the first time for sure! Give me a bulk connection GM!
Thanks for watching!
I have an 08 enclave with no crank no start no com amd gas gauge reads E but is full. When key in on position dash lights up perfect then when put to start all dash lights black out headlights go off and nothing until back in on position. Cannot figure it out have replaced starter, alternator, battery, and the engine was jacked up to replace motor mount. Checked all fuse box pins and fuses and relays have been checked and replaced, cleaned up and fixed wires to starter and back grounds.
Nice video, gm continues to impress about every mechanic in poor design lol
I need to know if the air bag wires are cut or damaged, WILL IT PREVENT THE VEHICLE FROM CRANKING???
I changed out that fuse relay instrument panel wiring harness Junction block without disconnecting my battery. And now I have no power. What can cause this?
I just purchased a 2013 Buick Enclave and it is stuck in anti-theft. I took it to the auto electrical shop and they are saying it may be a issue between the BCM or wiring dropping voltage. The last thing that was done to this cat was changed battery cause the old one had a shortage cell and was stinking the car up. Right now it’s not cranking and the anti-theft light stays illuminated. Note this car drove and operated just fine after the battery change but later that night it would not crank. Battery is fully charged and brand new
A lot of times when the battery is changed and proper procedure is not followed it can damage the bcm.
Did you fix your problem with your theft system on your buick. If not check the smart Junction box for water Intrusion and green crustys . I just worked on one with a few problems and I found that water was getting in through the sunroof and getting in the smart Junction box and I know it controls the theft system
Always interesting and informative. You are an exceptional talent. Thank you for sharing. I found it humorous when you inferred that a 2008 is old. I am still driving OBDIs. Haha.
Any follow up or link to replace the head light module? Thx
I'm having a similar issue on a 2012 Enclave and wondering if the repair work I recently had done had an impact on that wiring harness. I had the Water Pump replaced and when I got the vehicle back, the check engine light went on and the car wouldn't start on the first try. The shop check the codes and told me to have a lock smith replace the security key fob. Lock Smith says that wasn't the problem. Take it back to the shop who then tells me it's something on the computer board which is 6 weeks out. I drove it until it finally wouldn't start anymore. The car stalled while driving about 30 mph once during this time. How difficult is it for a layman to figuring out this wiring stuff?
So does the headlamp module need to be replaced and can you show the location?
So what dis you replace on the 08 enclave???
I have a 2008 Buick enclave cx sometimes it won't crank and I play with the switch of and on and it will crank up and sometimes it would crank so I play with the switch
Which switches mines doing the same the battery switches ?
Liked and subscribed.
Could this cause the PWR/TRN Relay to click continously around twice per second and still to run, start, crank, or starter click?
New fully charged battery, everything else works.
Thanks
I would not think so
I have been having issues of interment comm issues on the same year car with the articulating head lights. Also the right headlight does clicker sometimes. I haven't been able to catch it in the act with my scope. Is the headlight module in the headlight assembly itself?
yes it is
I have a 2009 buick enclave never has never been engine changed out yet I have no power yes I changed the battery can you help please?
I drive mine for a while then all of a sudden when i start it up it has no juice...i have to play with the battery wiring on the floor and then power comes back eventually....any idea whats the issue sir?...and yes there is something wrong with passenger headlight...i had to wire a ground to the headlight bulb and it worked again...i changed bulb then ballast...then saw the ground issue
...thanks for any feedback.
Mine is saying pass through connector. Don't know where it's located.
Question what version of Java do you use for gm sps programming??
How do I learn more about this program
So what cause car can't start?
2011 Buick enclave 3.6 l blowing even coil fuse when ignition is turned on have any idea
Did uou try unplugging coils and see if it stoos?
You’re Right Very stupid design . Thanks for your time
My Buick quit while going down road now won't start at all any suggestions??
I know this is a year later but this is the exact thing that happened to me too. Did you ever figure out what the problem was?
😂 wo these buicks are trash, had mine park up for 2 years now I'm back watching these vids again. This Jeep is the worst car I ever owned.
@@AaronMullings same here, just parked it now I’m working on it again but not having a lot of luck. Any luck figuring out what’s going on with yours?
Seems I need an electric guy, got it to start cranking today, definitely bad ground for me it a power issue. I played with the wires behind fuse box and engine.
Good job
i got 64.7 ohm 6 and 14 what do you suppose is next i wish i had alldata alls i get is identifix
Which modules do not communicate?
Made it look line is inposible
What a stupid design. I had the same problem. Just did the timing repair. While the right headlight isn't connected you have no start no communication issue.