DIY Hard Drive Motor Grinder: Step-by-Step Build Guide

This video describes the process of making a medium load Grinder from a scrap Hard Drive Motor with the use of an esc driver and speed controller.
This is a three (3) wire ESC module for three connector brushless motor.
Parts used here are as follows:
1. HDD Brushless Motor.
2. HDD Disk.
3. ESC Motor Controller Driver with Speed Controller
4. 12volt Battery Or 12 volt DC Power Supply.
5. Grinding Paper.
6. Feviquick.
7. Some Screws.
8. Insulated Wire.

[@pratikbhattacharjee-m9u]

How we shall arrange these materials that you have used in this video?