How to make an Offset with Duct Board
HTML-код
- Опубликовано: 19 сен 2024
- Hey guys in this video, I demonstrate how to perform a offset with duct board. I hope this video is informative , also please like and subscribe.
share.getjobbe...
Jobber is the tool I use to book more work, schedule smarter, and get paid faster. Sign up today for a 2 week free trial.
How to make Duct End-Cap
• How to make Duct End-Cap
How to make 90* elbow with Duct Board
• How to make 90* elbow ...
How to cut Duct Board W/Amcraft Layout Square /V-Groove method
• How to cut Duct Board ...
Cutting Duct Board W/ centerline method using amcraft tools
• Cutting Duct Board W/ ...
Can we do it in sheet metal duct?...same process
It's actually 1.41 11:06 doesntit really matter on small Cuts but on larger it would make a difference
you should try and use the male tool and cut two of your cuts to make the connection stronger
Thanks for the feedback 👍
What is the 1.4 for I always do the owl method offset witch is 3 times the width divid by length witch gives you the distance between the cut
1.4 X Offset gives you the distance between your first and second cut when you use a 22.5* template. Around 3:40 in the video you should see the two marks where the template will lay on for a reference point. I got the 1.4 from a few good mentors they said don,t question it just use it. 😂
I have a have 25 inches metal duck length...and its 12×12 ... I need a offset of 10 inches ....can i use the same process..like you did in this video...i don't have the template...can i use my square ....nornal square....and put 22.5 on it ?
Yes its the same process , and a square will work too 👍 good luck bud
The easiest way to make an offset is just times it by 2 so if you're going to 3 inch offset but you need to do in between the marks is measure it'll be six just times the three by two if it's a 7-inch offset it'll be a 14 you see how I did that 7 inch offset times it by two 12-in offset times it by that is the easiest way to do it and plus you need to know the length so how far off is your offset so if you got a piece of duck in the air and you got to go a little bit further I mean your ducks going to be attached so you know it need to know where the offsets going to be can you measure to the offset spot and then you just times it by 2 it's pretty simple
Can you make a vedio how to make a box top and how to 4 peice please.
I like this video I hope your next video teach how to do 45
45 just use the 22.5 angle back to back fold duct in and tape
Keep up the work. what size duct is that one in a half?
Thank you, and yes its 1-1/2” duct. 👍
200/200 Ofset 150sending vidio
Thanks 👍