Cordless Drill Stand From 795 DC Motor and PVC

DIY - Making a Cordless Drill Stand from a 795 Dc Motor Using a PVC Cover
segments
00:00 - Opening
00:49 - Parts
01:49 - Make Motor Cover
05:22 - Making sliding rails
07:27 - Installing the sliding rail mount
09:13 - Installing Motor cover on the stand
10:08 - Handle parts
10:35 - Making a handle
11:28 - Installing the Battery holder
12:05 - Installing the Switch
14:02 - Switch test (Reciprocating rotation and speed control)
14:46 - Wood Drill Test
16:00 - Closing
Parts:
- 795 DC Motor
- 795 Motor Bracket
- 20 Volt Cordless Battery
- Cordless Battery Drill Switch (7-36 Volt)
- Cordless Battery Socket
- PVC Sheets
- Timing pulley 16T B5 W15
- Timing pulley 48T B8 W15
- Timing Belt 110T W15
- 8mm Axle Rod
- KFL08 Bearing Bracket
- B12 Drill Chuck
- Connecting Shaft Rod adapter B12 Chuck
- V bearing 624ZZ
- Bearings 635Z
- Spring length 8cm, wire thickness 1.2mm OD 8mm
- Aluminum Strip 40cm x 3cm
- M4 nuts, M4 washers, M4 bolts, screws
Visit the Creatividea Channel
See other videos here:
/ @creatividea
Don't forget to LIKE, SUBSCRIBE, and provide suggestions and comments
Thank You

[@carlos.galhano]

Please, next time, provide where we can buy all the material. It's very difficult to see where we can get all the material. Nice video; this is only a suggestion.

[@Y.U.Y_1575]

Beli PVC sheet habis berapa bang?

[@kikihermanto4974]

kalau dinamonya mengunakan 775 dc bisa kah bg ?

[@creatividea]

bisa

[@Airbuashao]

Сможет ли такой двигатель сверлить металл?

[@creatividea]

Только для мягких металлов