Hello. I have too low voltage in the network when starting the engine. I need to change the low voltage setting from 330V to 320V. How to define a password to change the setting?
May I just want to ask, why the voltage reading at compressor panel is 320V only but the transformer indicates 400V to 410V..the compressor can not start because the motor is 380V..what are the parameters to set? Thanks
Hello I have waiting for solution FSCURTIS 7.5 SC 2000 Controller Problem under voltage/low voltage Suggest me to solve this problem with given setting........... 🙏Please
How set unloading pressure?
This code is used for all mam 880 module? Plz reply
Hello. I have too low voltage in the network when starting the engine. I need to change the low voltage setting from 330V to 320V. How to define a password to change the setting?
May I just want to ask, why the voltage reading at compressor panel is 320V only but the transformer indicates 400V to 410V..the compressor can not start because the motor is 380V..what are the parameters to set?
Thanks
errors may occur readings in control of your monitor
hello, do you know what is the key to change the frequency from 50 to 60 HZ
Try with 0388
Nice work
Over voltage
Do you know what to do for ERROR "fail to stop" is?
"fail to stop" includes several errors. to find out in more detail where the error is, please go to the fault history menu.
What is the password for factory parameters.. Low voltage... Although the right voltage on tester..??
Sir mera motor overload kyo batane lgta hai
Why is it after i go to factory para.. I can't able to chnage the voltage.. Can you please help me
Códigos por favor
Hello sir please help me...what should i do Highvoltage problem
you have to lower the voltage. contact the electric service in your place
Do you have Facebook so i can contact you
Leo kurdianto
Me aparece un fail yo stop y no enciende
Mam 860 showing the machine Low voltage 307
but I'm checking the voltage . There's 400
What is the solution?Brother
Try to change the frequency setting. Use 0388 password to change 50Hz to 60Hz
Hello I have waiting for solution FSCURTIS 7.5 SC 2000 Controller Problem under voltage/low voltage Suggest me to solve this problem with given setting........... 🙏Please
I'm sorry to bother you with the wiring of the MAM880 control system.
can I help?
When the motor is unloaded, can I want the motor to stop spinning?
I rarely use the wind to waste energy.
So I want the motor to stop spinning when the wind is full.
you have to set the dead time of the machine after the wind met. because of the manufacturer in stell 360 seconds after the wind met
Oil change reset code plz help me
1111
@@leokurdianto8748thnx sir but its not working on mam 880 controller
@@leokurdianto8748 plz reply
you must be logged in setting the clr life time. then clear the desk of his. before it should enter password
@@leokurdianto8748 not work it need password code
High voltages password???
Sir please compressor me phase error ko kese thik kare
Sir please give me password
Plz share factory password
Waduhh Pasword Factory sensor Broo, nanti di salah gunakan jd rusak deh, hehe...
ruclips.net/video/81Lv3ZjBEEw/видео.html
Please confirm pressure satting pasward