Note that there’s a large number of causes for P219a - MAF, vacuum leak, exhaust leak upstream of the O2 sensor, faulty O2 sensor, bad injectors, bad plugs, bad coils. If you’re not seeing misfires, it’s less likely to be failing injectors/plugs/coils.
Thank you! My car had been shaking a little when I slowed down, almost like sputtering. It had been doing that for some time. I changed the pcv valve, spark plugs but that didn't help much. I'll check the fuel injectors now!
2017 ford f150 3.5 ecoboost: I had a P2237 (bank 1 sensor 1) code, so I replaced the O2 sensor. After several drive cycles, everything seemed fine. After two weeks. I got a P219A code. The vehicle seems to be diving fine, and is very smooth. I just purchased some fuel system cleaner (Chevron) and hope to see if this helps. But if it doesn’t, I will need to diagnose the issue. Any advice?
Looks like the problem with the fuel was already present it was not throwing code because of the bad o2 sensor. After the sensor changed, it worked and started sensing the fuel lean or rich. Now, you should start checking the air leaks on manifold before the o2 sensor and intake. If all is good, then go with injector cleaning injector cleaner liquid won't do anything
Yes its possible but when engine is misfiring you due to bad o2 sensor then you can check by removing o2 sensor connector (run engine without o2 sensor ) if there is no missing then chances of bad o2 sensor is very low there is also possibility on air intake leaking But start with injectors buy acdelco carburetor cleaner (not injector cleaner) remove injector and dip front end in acdelco carburetor cleaner for 10 minutes then with brush clean gently then dip again for 5 minutes then install it
I have 2016 dodge grand caravan that has p219a code. I changed o2 sensors, map sensor and injectors. I still have the code. No other codes except p219a. Is this code associated with ignition coils and spark plugs? Thanks
No its not due to o2 sensor three most common issues leak air vacuum from intake or injector O-rings , injector need to clean or exhaust gas leak before o2 sensors. Tips, You can use bottle of water with hole in cap then start test air vacuum leak with water with start engine you will hear air water suction sound ( check leak for intake and injector o-ring)
@@CarFaults 3h 47min 😭too much far..can you guide me something please? I have checked in computer and got 1probelm.. have a code of p219d cylinder 2 air fuel ratio imbalance ...my vehicle some time missfire and engine light and track off light both comes ..what you think what will be the issue? I changed spark plug and coil ..but still comes ..
Just clean injector nothing more Remove the injector place in ac delco carburator cleaner for 15 minutes then gently clean with brush. Note : don't use any cheap carburator cleaner other then ac delco otherwise injector will damage and engine will take two to three self to start when cold
Yes you should go with injectors first injector cleaner will not work when carbon already build up on injectors so you need to remove and clean you can remove them and dip in ac Delco carburator cleaner for 15 minutes and clean injector heads with tooth brush gently ( do not use other cleaners which evaporate only use ac Delco or something same as ac delco )
@@CarlosElHalabi ended up being a coil pack for me. Even though the code said crank sensor. I didn’t touch/do anything else besides replace the coil pack. Driving and waiting to see if it comes back. The misfire is gone. Everything is normal right now.
Is there any other codes ? If no then it’s injector if for any reason you are unable to check injector then change the location of injector and clear the codes then see which cylinder shows codes
Hmm it means you have multiple cylinders issue you also feel engine missing when driving ? If yes then you need proper diagnostic tool open misfire data then drive once you know which cylinder is missing and which is not missing swipe injector between missing cylinder and not missing cylinder For this engine i found many issue Mostly injector Plug Bad head gasket Catalyst converter blocked Bad oxygen sensor
@@afgluda oh maybe by misstake for engine Missing you need to check spark coil then spark plugs then injector if all good then maybe engine it self low head pressure
I have the code p219a with cylinder 3 missfiring, i changed the spark plug and spark coil but the problem is still there. Do you its oxygen sensors or fuel injectors?
@@afgluda no o2 sensor handle all four clyinder not only no3 you should go with injector.clean injector with ac Delco carburator cleaner or change location of injector then check again if still no3 missing or not
Note that there’s a large number of causes for P219a - MAF, vacuum leak, exhaust leak upstream of the O2 sensor, faulty O2 sensor, bad injectors, bad plugs, bad coils. If you’re not seeing misfires, it’s less likely to be failing injectors/plugs/coils.
So if you don’t have a misfire that’s kind of a good thing it just means there might be a leak in the evap system?
Your English is fine thanks you!!
Good diagnosis and repair
Thank you! My car had been shaking a little when I slowed down, almost like sputtering. It had been doing that for some time. I changed the pcv valve, spark plugs but that didn't help much. I'll check the fuel injectors now!
Hope you find problem soon also clean throttle body!
2017 ford f150 3.5 ecoboost: I had a P2237 (bank 1 sensor 1) code, so I replaced the O2 sensor. After several drive cycles, everything seemed fine. After two weeks. I got a P219A code. The vehicle seems to be diving fine, and is very smooth. I just purchased some fuel system cleaner (Chevron) and hope to see if this helps. But if it doesn’t, I will need to diagnose the issue. Any advice?
Looks like the problem with the fuel was already present it was not throwing code because of the bad o2 sensor. After the sensor changed, it worked and started sensing the fuel lean or rich.
Now, you should start checking the air leaks on manifold before the o2 sensor and intake. If all is good, then go with injector cleaning injector cleaner liquid won't do anything
@@CarFaults the chevron fuel system cleaner worked!
I have
P0302
P219A
P219D
Possible, F. Injector too???
Thanks!
Same problem. And I fixed thanks to you👍💪💪💪🌟
Cuanto cuesta eso?
All the support to you brother 👍
I have that p219A on a Toyota Corolla S. I just did plugs on it. Should I check the injectors then? Please let me know asap.
Yes if check injectors if not injector then check cylinder pressure
It’s not possible that it’s a pcv or a o2 sensor. It idles fine. I also only had that code no other code. No misfire codes or anything just that code.
Yes its possible but when engine is misfiring you due to bad o2 sensor then you can check by removing o2 sensor connector (run engine without o2 sensor ) if there is no missing then chances of bad o2 sensor is very low there is also possibility on air intake leaking
But start with injectors buy acdelco carburetor cleaner (not injector cleaner) remove injector and dip front end in acdelco carburetor cleaner for 10 minutes then with brush clean gently then dip again for 5 minutes then install it
Thank you! Very informative
I have 2016 dodge grand caravan that has p219a code. I changed o2 sensors, map sensor and injectors. I still have the code. No other codes except p219a. Is this code associated with ignition coils and spark plugs? Thanks
No its not due to o2 sensor three most common issues leak air vacuum from intake or injector O-rings , injector need to clean or exhaust gas leak before o2 sensors.
Tips,
You can use bottle of water with hole in cap then start test air vacuum leak with water with start engine you will hear air water suction sound ( check leak for intake and injector o-ring)
I have 2 codes p219a and p219b you think it could be 02 sensors
Yes it could be o2 sensor
Hi which place you are in Oman ? Want to visit your garage
Search Garage Al wali on google you will find me!
@@CarFaults 3h 47min 😭too much far..can you guide me something please? I have checked in computer and got 1probelm.. have a code of p219d cylinder 2 air fuel ratio imbalance ...my vehicle some time missfire and engine light and track off light both comes ..what you think what will be the issue? I changed spark plug and coil ..but still comes ..
@@CarFaults please help me regarding this
@@saeem8701 Make and model of car ?
@@justtrue8228 American specs .model 2014
2014 Tundra 5.7 with P219c Cylinder 1 air-imbalance. Help?
Just clean injector nothing more
Remove the injector place in ac delco carburator cleaner for 15 minutes then gently clean with brush.
Note : don't use any cheap carburator cleaner other then ac delco otherwise injector will damage and engine will take two to three self to start when cold
I happen to have a p219f and a p219d code, would thse fall under the same category?
Please give me more details about car make model and year
@@CarFaults 2019 corolla LE with the 2zr fe engine
Yes you should go with injectors first injector cleaner will not work when carbon already build up on injectors so you need to remove and clean you can remove them and dip in ac Delco carburator cleaner for 15 minutes and clean injector heads with tooth brush gently ( do not use other cleaners which evaporate only use ac Delco or something same as ac delco )
Would a bad crankshaft sensor(p0335) cause p219a and p0302?
These are the 3 codes I have.
Never crack sensor will give you only p0335 no other codes
I have the exact 3 same codes. P219A, P0302 and P0335
@@CarlosElHalabi looks like you need to clean fuel injectors also check for air intake leaks
@@CarlosElHalabi ended up being a coil pack for me. Even though the code said crank sensor. I didn’t touch/do anything else besides replace the coil pack. Driving and waiting to see if it comes back. The misfire is gone. Everything is normal right now.
Mercedes CLA 250 need help with code P219D
Is there any other codes ?
If no then it’s injector if for any reason you are unable to check injector then change the location of injector and clear the codes then see which cylinder shows codes
@@CarFaults also showing P219c and P219F
Hmm it means you have multiple cylinders issue you also feel engine missing when driving ? If yes then you need proper diagnostic tool open misfire data then drive once you know which cylinder is missing and which is not missing swipe injector between missing cylinder and not missing cylinder
For this engine i found many issue
Mostly injector
Plug
Bad head gasket
Catalyst converter blocked
Bad oxygen sensor
sir where are you from
Oman
What is spark wheel
Maybe spark plugs not spark wheel 🤔
@@CarFaults you said 4 things, the first one spark wheel and the second spark plug
@@afgluda oh maybe by misstake for engine Missing you need to check spark coil then spark plugs then injector if all good then maybe engine it self low head pressure
I have the code p219a with cylinder 3 missfiring, i changed the spark plug and spark coil but the problem is still there. Do you its oxygen sensors or fuel injectors?
@@afgluda no o2 sensor handle all four clyinder not only no3 you should go with injector.clean injector with ac Delco carburator cleaner or change location of injector then check again if still no3 missing or not
حساس الاوكسجين
I have a scion iq and in the scanner I get code p219a
Mostly injector or intake manifold leak