how to replace metabo planer knives

[@TheLastPharm]

Nice job, I have this exact same planer. My knives are very dull and thought I needed to order new ones. I didn’t realize they were double edged and only need to be taken out and turned around. You just saved me some money. Thank you very much!

[@reinhardtpienaar1316]

Thank for this comment!

[@99Thias]

thanks - i did know, the knifes are double edged ! good explaines and demonstrated in this video !!!

[@chrislambert9435]

Thankyou I benefitted from your video . . . Chris ... Norwich, England

[@oembol]

Thanks Mardak, exactly what was I was looking for.

[@adamik62]

Thank you for the video, I'm going to replace my knives :)
Greetings from Poland.
Adam

[@rohan175]

Brilliant and very useful video, thank you.

[@mardakworkshop4450]

thanks for watching ❤️❤️❤️❤️❤️

[@romankrajcovic]

It helped me a lot, thank you.

[@cheshiregunroom]

Thank you so much. You are a legend

[@ReplicantDream]

Perfect video. Many thanks

[@حسینهاشمی-ظ1ث]

Thank you for teaching

[@davidblythen2655]

Any idea on how to adjust the chain on a metabo dh330 planer and thicknesser after cog replacement ?

[@tibortakacs968]

Köszönöm szépen /Thank you/

[@frankleiner8357]

Danke für die Infos. Wie wechselt man an diesem Teil den Antriebsriemen für das Messer?

[@TheAlogoc]

Is there any fine tuning of the blades needed or do they just fit into place?

[@mardakworkshop4450]

Goran jelenić there is no tun for this model it fits in a gaid

[@TheAlogoc]

@@mardakworkshop4450 thanks...and what if you sharpend the blade...how do you compensate for material lost during sharpening...the mesurment should be off?

[@mardakworkshop4450]

Goran jelenić this type of knife you make it upside down for the first time then you replace it if damage again

[@TheAlogoc]

@@mardakworkshop4450 you are not allowed to sharp it?

[@mardakworkshop4450]

Goran jelenić no you cannot for this model

[@fester.]

great vid,in the booklet it states you get a special tool to change the blade,mine is missing and you never used one,did you get one

[@boriszeijstvan7634]

Montage of the cheap plastic cap above the knives , is the most work. To find the screws back and fit into the machine < that part is missing .

[@mardakworkshop4450]

depend on your wood check for nails first and don't feed it too much go very slow

[@TheEvilways101]

Nice

[@josipbozic2311]

Prevedi na hrvacki