(S-2 Ep-43) DIY Drawer Slide Jig (FREE PLANS)
HTML-код
- Опубликовано: 8 сен 2024
- FREE PLANS IN BOTH IMPERIAL & METRIC DIMENSIONS!!!
Here’s a very simple, fast, cheap, and easy jig you can make to help locate and hold drawer slides in position while you screw them into place.
Link to FREE PLANS download here:
www.downeastth...
Many thanks to all my subscribers for participating, commenting, liking, and sharing my videos. I very much appreciate your continued support of my RUclips channel. It’s a lot of fun for me, and I hope this trend continues.
Please Subscribe today, “Like,” and Share. Thanks for watching!
Websites:
www.downeastth...
www.shoestring...
I know this must have seemed trivial to you, but it helped me out with a simple thing I was struggling with for some reason, so thank you.
Now that I think of it, I haven't been on a construction site where a "Jig" wasn't used (industrial construction, oil & Gas mostly)
They're the "unsung heroes" of building anything, really...
Thanks again Bud.👍🏻
You're welcome! I'm happy this worked out for you. I mostly work alone and don't have someone to lend another pair of hands when needed, so I usually make some sort of tool or jig to help with the project out of necessity. Thanks for watching and commenting! 👍👍👍
This made it SO easy. I used the same thing to line up shelf support holes.
Glad you like it!
I was just looking at some rather expensive, in my book, drawer slide jigs and saw your video. Thanks for sharing. This will save me a lot of aggravation and unnecessary cost on the drawer build, I am getting ready to do.
You're welcome, Jimmy. Good luck with your build.
Very helpful video and instruction. Yet another thing I have yet to learn...
Glad it was helpful!👍👍👍
So simple and so cheap.. Thanks for sharing
You're Welcome, Hamid Khan! Glad you like it!
Thank you for your time making this video and this tool. Tku
You're welcome, Alberto!
way late seeing this but would it be possible to just drill the holes through the tsquare and use the tsquare as the jig itself?
Very useful jig ,thanks a lot
You're welcome, Siva Rama Krishna! I'm happy you found this DIY tool useful.
Where do you attach the clamp if the cabinet box is already installed?
Thanks for your comment, Russell. A simple solution is to pre-drill a couple of small holes in the long section of the jig. Hold the jig in position with the "T" part of the jig against the cabinet so you know the jig is square. Holding the jig in the proper position, run a couple of screws through the long section of the jig into the inside surface of the cabinet. Make sure the screws are a short enough length such that they won't break through the cabinet wall on the other side. Then go ahead and install the drawer slide. It's not as convenient or as fast this way but it works. I'm sure there may be another way someone might think of but of course you always have the option of simply spending the money on one of those new, whizbang plastic clamps from Kreg or Rockler, etc.
Can I get the plans please
Absolutely, Derek! Simply follow the instructions provided in the description below the video - no problem. You'll be able to download them in pdf format.