The new 48v jetson setup

[@BarbeRodzTV]

Nice one bro dobro 👍🇭🇷

[@jasmineNcisco808]

What type of Ring connectors did you use on the yellow, blue, and green wire from the hub motor since you copied the wire setup as the KT controller.

[@Satori-Project]

Connection Insulation Phase Box, you can get them on amazon

[@jasmineNcisco808]

@@Satori-Project I have the phase box but what type of connectors did you use to connect in the phase box? I been trying to find the right size Ring connectors

[@HelloICyou]

Pinkie u got a extra jetson bolt pro motor a 72v one I’ll trade u a stock jetson bolt pro for it lmk or price ??? Lmk

[@firstmotorhome8024]

Did you take off the back brakes ?

[@DenDen-dv1qe]

hello, I have the same bike, with the same motor, I’ll tell you a secret, a 48 volt motor and a 72 volt motor are no different, I see you have several upgrade errors, firstly a battery, for such powerful configurations you need a powerful battery, you need to make sure that the assembler put in the battery is a suitable bms board, it must be at least the power of the controller, if the controller is 50 amps then bms needs 60 amperes, even the wire on your battery does not match, for such currents you need a minimum of awg 12, secondly, the controller for such an engine must be at least 50 amperes, and sine is better, you have a square one so the engine is noisy, a good yellow Jrahk sine controller, it is easier to set up than KT

[@royalvibes4433]

Bro, simplify what you are saying here . Please & thanks

[@DenDen-dv1qe]

@@royalvibes4433 если проще то этому мотору для увеличения скорости ненужно поднимать напряжение,ему нужно увеличивать мощность контролера(амперы) и фазный ток,при правильном контролере этот мотор способен развивать 90-100км/ч, но для этого нужно убедиться что ваша батарея способна отдавать такие большие токи