Narrowing a High Pinion Dana 44 for 1966-77 Ford Bronco

How to narrow a 1978-79 F-150/Bronco high pinion Dana 44 front axle housing for a 1966-77 Ford Bronco. The why's and how's of cutting down a front axle housing.

[@NashvilleEarlyBronco]

Good info 👍🏼

[@JW-cn6op]

A way to cut straight is put a hose clamp on and saw/ cut off wheel. If you pull the tune out of the housing then it will need machined outside to fit back in and a new inner seal surface on the inside.

[@michaelwelch5392]

Having done one 20 years ago. I would also cut down the drivers side as much as possible to move it for more drive shaft clearance. Just saying . But good info.

[@deanhubbard9599]

Do you have a video on removing the wedge castings from a 74 to 77 F 150 / Bronco front axle to put spring perches on?

[@simpsonoffroadllc]

I don't but if you look at them they just have welds on the top and bottom of them that parallel the axle tube. If you just cut down on those roughly to the axle tube then take a hammer they will come off