HARSLE Smart Press Brake Machine Operation Tutorial - DELEM DA-53T

#DA53T #HARSLE #tutorial
Smart Press Brake Operation Tutorial
Part 1
Fill The Oil and Cable Connections
Controller cable connection.
Filling the oil tank with anti-wear hydraulic oil.
Fill the oil from this port.
No less than Two-thirds of the Oil Volume Level.
Connect the machine to the power source.
Connect the cable to the electrical box.
Connect the earth wire.
Connect to a three phase power source.
Connect the pedal switch to the machine.
Switch on the power source.
Connect the pedal switch to the machine.
Turn on the machine power switch.
Waiting for the system loading.
Check the main motor's rotating direction.
Pull down the soft buttons.
Press the pump-start button shortly.
Check the main motor's rotating direction.
If it rotates clockwise, then It is correct.
If it is rotating anti-clockwise.
Exchange the two wires connection.
Part 2
Machine Start-up
Turn on the machine power switch.
Waiting for the system loading.
Release the emergency stop buttons.
Pull down the soft buttons.
Turn on the lights.
Press the pump-start button.
Press the start button and find reference points.
Finding reference points is done.
Test the X-axis running.
Test the R-axis running.
Test the crowning system running.
Check the tooling parameters.
Measure the tooling to compare with the data.
Part 3
Bending Programming
Input the password forty two.
Input the product ID.
Input the sheet thickness.
Selecting the tooling.
Input the bending length.
Input the bending angle.
Enter the X-axis distance.
Add the second bending step.
Check program data.
Ready to start.
Part 4
Bending Products
Place the metal sheet.
The sheet will touch the stop fingers.
Step the pedal.
Complete Step one.
Press the pedal.
Complete Step two.
Part 5
Measurement And Calibration
Measure the first bending distance.
Measure the second bending distance.
Using the angle ruler.
Measure the bending angles in three positions: left, middle and right.
Error found.
Measured at ninety one degree.
Enter the calibration parameters minus one.
Bend again for testing.
Measure again.
It is correct now.
Part 6
Other Functions
Laser Protection
Input zero one to open laser protection.
The slider will brake immediately once the laser is blocked.
Input zero zero to close laser protection.
The slider will run normally even if the laser is blocked.
Pedal Control Mode Switch
Pull down the soft buttons.
Click the blue-button to open the Jog Mode.
The slider will press down when stepping the pedal.
And slider will stop accordingly when stopping to step the pedal under the Jog Mode.
Click the blue-button to open the Retract Mode.
The slider will press down when stepping the pedal.
And slider will retract upwards when stopping to step the pedal under the Retract Mode.
Safety Light Curtain
Once an obstruction enters the protection zone.
The slider stops moving.
The control system will also alert immediately.
Part 7
Switch Off
Step the pedal switch to lower the punch against the die.
Press the stop button.
Switch off the pump.
Press the emergency stop buttons.
Turn off the power switch.
Press Brake Division
www.scoson.com
Tooling Division
tooling.harsle.com
9-Axis CNC Press brake
• HARSLE Genius CNC Pres... ​
Operation Download
www.harsle.com/download.html​​
Contact Us
www.harsle.com​​
Email: [e-mail]
WhatsApp: [phone]

[@mohannarvekar9842]

Thanx you for operating process.