Woodcraft Technologies | Brake Light Switch

These universal switches allow rearset users to operate the rear brake light. This all-in-one unit replaces the banjo bolt that connects the rear master cylinder to the rear brake line. You simply replace the bolt with this assembly and splice the wires into your existing brake light switch. The pressure inside your brake system then activates the brake light.
Check out our application guide here: tinyurl.com/y7urqyq2

[@miareyna8126]

did anyone ever find an install video for this??

[@tobij5186]

Why is there no video on how to install this.

[@renedelafuente123]

Do I need two of these, one for the back brake and one for the front brakes in order for brake light to work with either brakes? Thanks for video, any feedback appreciated.

[@kyleessex6301]

So your front brake shouldn't be affected by the aftermarket rear-set, so you should just need the one for the back brake!

[@Tizzypj]

How can I wire this into a loom without brake lights?

[@benl4707]

get a brake light and run wires to brake light simple! if you want front brakes to work with the light get a lever that has a sensor and run the wires to the brake light

[@paulpopp1999]

So where do the wires go?, my tail light has 3 wires coming from it.

[@ChrisLue]

Of those 3 wires: 1. Power 2. Ground 3. goes to this switch.

[@jimmypricer9502]

@@ChrisLue nope 1 Power (tail light) 2 Power from switch (Brake Light) 3 ground