How to Replace Knock Sensor 2004-2008 Acura TL

Buy Now!
New Engine Knock Sensor from 1AAuto.com 1aau.to/ia/1AEK...
This video shows you how to install a new knock sensor in your 2004-2008 Acura TL. A knock sensor monitors your vehicle’s engine for unusual pulsations caused by things such as engine knock. If a sensor is damaged or malfunctioning, the engine may run poorly, inefficiently, or only in a low speed safe mode, and may also trigger diagnostic codes.
This process should be similar on the following vehicles:
2004 Acura TL
2005 Acura TL
2006 Acura TL
2007 Acura TL
2008 Acura TL
Tools you will need:
• 10mm Socket 1aau.to/oK5/1AX...
• 24mm Socket
• 8mm Socket 1aau.to/oK5/1AX...
• Hose Clamp Pliers 1aau.to/oa7/1AX...
• Ratchet 1aau.to/oWf/1AX...
• Socket Extensions 1aau.to/oSc/1AX...
• Torque Wrench 1aau.to/oBf/1AX...
• Electrical Tape
• Paper Towels 1aau.to/ohK/1AX...
• Pick 1aau.to/oj9/1AX...
• Telescope magnet
Subscribe: / @trq
Check out our playlist:
Acura TL 2004-2008 3rd Generation: • Acura TL 2004-2008 3rd...
⚠ DISCLAIMER:
While TRQ strives to make the information provided in this video as accurate as possible, it makes no claims, promises, or guarantees about the accuracy, completeness or applicability of the content. No information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. All do-it-yourself projects entail some risk. It is the sole responsibility of the viewer to assume this risk. TRQ is not responsible or liable for any loss damage (including, but not limited to, actual, consequential, or punitive), liability, claim, or any other injury or cause related to or resulting from any information posted in this video.

[@TRQ]

√ Watch the Video
√ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts
√ Do it Yourself
√ Save Money

[@jamesdiamond533]

Could you upload a Crankshaft Sensor replacement

[@stephenjackson4392]

Might suggest people plug those intake ports before tools or nuts and bolts fall inside.

[@kris.6988]

excellent, glad to find a video for this that's this thorough and well put together

[@dirtycomment2324]

After doing this job myself, just unbolt the throttle body and move it to the side, instead of fiddling with the hoses

[@coreymobley9979]

What’s the name of the new gaskets you installed?

[@DougLaurence]

Very helpful! Thanks so much for posting!

[@stephenjackson4392]

Great so you have to tear half the engine apart to change it

[@eightchickens]

Ok for non mechanic folks like me: no knowledge, no tools... ah well better pay up $300-$500 to get it professionally done. Thanks for vid anyway.

[@baselopez4042]

Size socket you use ?

[@wesleyhollaman9189]

24mm thin-wall deep socket. Your welcome