When you disconnect the battery, after the reconnection wait about 5 minutes before starting the engine to give the time to the fuseboxes to startup correctly. Then turn the ignition on, wait that all lights on the dashboard turn off, then start the engine and turn the steering wheel all to the left and all to the right to turn off the steering failure light and the VDC failure light. With this procedure you have initialized the Dual Pinion active steering. If you have the bixenon headlights you have to turn on the AFS function because when you disconnect the battery it turns off. Then you have to initialize the windows and the rear bonnet following the procedures that are written on the use and maintenance handbook of the Giulietta.
@@davedamn44 You must follow the instructions that are written on the use and maintenance handbook, later when you have reconnected the battery you must follow the instructions that I've written up here to initialize all the devices that need the initializing procedure.
ok thank you very much for your fast answer! so i need to check the handbook instruction for every warning? that's a minimum of 5 :o yesterday everything run well... i think it doesn't like the cold weather @@lucagovoni3420
I have the same problem. My battery was totally empty. I think it's bad. But on my car also the engine light turned on. And it stays on how do you fix this problem do you need to drive to a garage?
Just move the steering wheel from lock to lock (full left to full right) the steering is now recalibrated and that fixes all the other faults as well, easy😁
Just like any computer, sometimes it needs a restart - if the stop/start stops working, disconnecting the battery fixes it, and after a few minutes everything resets. I've done this loads of times with both Giuliettas I've had
I have a similar issue....if not the same...its also not letting me switch between modes....my theory is that when the battery was changed they didn't put back the right size battery and perhaps because of that everything else fell off the rails...?....thoughts?
Ésto ocurre en la mayoría de los autos con dirección electroasistida, en algunos casos la dirección se torna completamente dura, lo único que hay que hacer es conducir un lapso de mínimo 100 metros o girar de tope a tope la dirección para dar el reconocimiento, de igual manera tendrán que hacerlo con los vidrios de las ventanas y el quemacocos... Hay ocasiones como en Audi que el embrague pierde la calibración y hay que dar ajuste básico.
Hi i have the same problem and my steering has gone really hard.. i had a very weak battery which has no been replaced but was still worried why the steering was so hard.. Will definitely give it a little drive tomorrow and hopefully it all resets.
Hi i have a 2013 giulietta TCT, the problem is it does not engage gears.However it does start.And the fault code states check transmission. Any one who can help with a solution?
If it happens again just am have through wash of the engine if happen to me one time I had to wash the engine even before I left the washing bay it was all good
yes it just happened to me...it did not had power on the keys, and after 5 min it started like in this video... and after 4 Hours it happened again...but why ?? where is the problem ?? it.s the battery dead ??
@@aggelosntaflos9906 just drive it.. It's from removing the battery.. After you connect the battery again will do this.. But after 10 min driving or just letting the cat to stay a while, will be OK.. It's from board computer.. It's kind "restarting".. Nothing dangerous
@@outboundrules the problem with mine is that the check engine light is also oppened and it does not let me start the engine. When i check the 'check engine" light it showed me 12 errors while my car was in very good condition. The engineer told me that it is something electric like a short circuit beacuse it is very rare to have 12 errors at the same time. Do you have any idea what will be the problm? thank you in advance!
Φιλε μου, εδω και μερες μου εχει βγαλει μια ενδειξη οτι το αυτοκινητο χρειαζεται σερβις ενω ακομα εχει καμια 15.000 km περιθωριο, ξερεις πως να το φτιαξω αυτο?Επισης δεν μου δουλευει το blue&me. Το αυτοκινητο το πηρα πριν 10 μερες second hand. Αν ξεσυνδεσω την μπαταρια και την ξανασυνδεσω θα τα λυσω αυτα τα προβληματα?
Δεν γνωριζω φιλε μου,δοκιμασε το και μετα βαλε αερα στα λαστιχα εστω και λιγο μετα πατα το κουμπι set να κανει reset και βλεπεις αν δεν στρωσει μετα μονο αντιπροσωπεια κατα τη γνωμη μου δεν ειναι κατι σοβαρο
When you disconnect the battery, after the reconnection wait about 5 minutes before starting the engine to give the time to the fuseboxes to startup correctly.
Then turn the ignition on, wait that all lights on the dashboard turn off, then start the engine and turn the steering wheel all to the left and all to the right to turn off the steering failure light and the VDC failure light.
With this procedure you have initialized the Dual Pinion active steering.
If you have the bixenon headlights you have to turn on the AFS function because when you disconnect the battery it turns off.
Then you have to initialize the windows and the rear bonnet following the procedures that are written on the use and maintenance handbook of the Giulietta.
Hi Luca, i have the same problem right now... how to disconnect the battery?
@@davedamn44 You must follow the instructions that are written on the use and maintenance handbook, later when you have reconnected the battery you must follow the instructions that I've written up here to initialize all the devices that need the initializing procedure.
ok thank you very much for your fast answer! so i need to check the handbook instruction for every warning? that's a minimum of 5 :o yesterday everything run well... i think it doesn't like the cold weather @@lucagovoni3420
Start the engine, drive along a few minutes and everything will be ok. The computer needs a few minutes for the complete restart.
Norbert Agócs this is true.
I have the same problem. My battery was totally empty. I think it's bad. But on my car also the engine light turned on. And it stays on how do you fix this problem do you need to drive to a garage?
@@MrEdwinthaking me too. What did you do?
@@aggelosntaflos9906 simply drive it's just a simple malfunction
It is work!!!! Thank u
Just move the steering wheel from lock to lock (full left to full right) the steering is now recalibrated and that fixes all the other faults as well, easy😁
Thanx Man! Fixed
You have to reset the windows too but other than that you're correct.
So I noticed as on mine no battery light when ignition on , is there a reason for this ?
All fixed except steering corrector. The car runs fine but this messages dont let me switch between all weather or dynamic
How can i reset the vdc.I have a error to my Alfa romeo 159 1.9jtd VDC unavailable see handbook, how can resset this error?
Just like any computer, sometimes it needs a restart - if the stop/start stops working, disconnecting the battery fixes it, and after a few minutes everything resets. I've done this loads of times with both Giuliettas I've had
It's nothing to do with the gearbox
I have a similar issue....if not the same...its also not letting me switch between modes....my theory is that when the battery was changed they didn't put back the right size battery and perhaps because of that everything else fell off the rails...?....thoughts?
Hi, did you manage to fix this?I have the same problem including the dna right now and need some help.
Can you solve?
Ésto ocurre en la mayoría de los autos con dirección electroasistida, en algunos casos la dirección se torna completamente dura, lo único que hay que hacer es conducir un lapso de mínimo 100 metros o girar de tope a tope la dirección para dar el reconocimiento, de igual manera tendrán que hacerlo con los vidrios de las ventanas y el quemacocos... Hay ocasiones como en Audi que el embrague pierde la calibración y hay que dar ajuste básico.
Lo indica el manual además 😉
Just drive the car and the problem will fix itself after a few minutes. Had the same last week
Hi i have the same problem and my steering has gone really hard.. i had a very weak battery which has no been replaced but was still worried why the steering was so hard.. Will definitely give it a little drive tomorrow and hopefully it all resets.
I have excalty the same problem how did you fix it
@@bashirjumale i put in a new battery and just drove it for abit and it didn't do it again
Take it for a drive and it will clear. Mine did 💯
How do you fix this problem it goes away an keeps coming back it's so annoying what do I do plz help if possible
Can you solve?
Turn wheel full lock left then right. It’ll reset.
Hi i have a 2013 giulietta TCT, the problem is it does not engage gears.However it does start.And the fault code states check transmission.
Any one who can help with a solution?
Edward Ditaba come here to read the comments . Have same issue recently “check transmission book “ . Did u manage to set it up ?
If it happens again just am have through wash of the engine if happen to me one time I had to wash the engine even before I left the washing bay it was all good
I have same problem and it doesn’t starts at all, can some one advise how do I fix this plz . Thx
just drive for 5-10 min. so the computer restart completes.
yes it just happened to me...it did not had power on the keys, and after 5 min it started like in this video...
and after 4 Hours it happened again...but why ?? where is the problem ?? it.s the battery dead ??
@@outboundrules What was the problem at the end? Did you fix it?
@@aggelosntaflos9906 just drive it.. It's from removing the battery.. After you connect the battery again will do this.. But after 10 min driving or just letting the cat to stay a while, will be OK.. It's from board computer.. It's kind "restarting".. Nothing dangerous
@@outboundrules the problem with mine is that the check engine light is also oppened and it does not let me start the engine. When i check the 'check engine" light it showed me 12 errors while my car was in very good condition. The engineer told me that it is something electric like a short circuit beacuse it is very rare to have 12 errors at the same time. Do you have any idea what will be the problm? thank you in advance!
how did you fix this? it has just happened to me
I did yesterday and after 10km drive everything was normal
What they say does not apply. You put air on the tires after the set button and make reset and all is ok...
I have suffered the same
Φιλε μου, εδω και μερες μου εχει βγαλει μια ενδειξη οτι το αυτοκινητο χρειαζεται σερβις ενω ακομα εχει καμια 15.000 km περιθωριο, ξερεις πως να το φτιαξω αυτο?Επισης δεν μου δουλευει το blue&me. Το αυτοκινητο το πηρα πριν 10 μερες second hand. Αν ξεσυνδεσω την μπαταρια και την ξανασυνδεσω θα τα λυσω αυτα τα προβληματα?
Δεν γνωριζω φιλε μου,δοκιμασε το και μετα βαλε αερα στα λαστιχα εστω και λιγο μετα πατα το κουμπι set να κανει reset και βλεπεις αν δεν στρωσει μετα μονο αντιπροσωπεια κατα τη γνωμη μου δεν ειναι κατι σοβαρο
thanks
Hello, where is the Set button and how to reset? Thank you
@@rio20071111 I'm also looking for this button