@@stephenharris6769 yep. Heat it up a while with a torch and it should come off pretty easily. Same thing for install. Heat it up and slide it back on. good luck! I mangled my original before learning this and had to get a replacement.
Блин, серьезно? Все видео сводится к тому как открутить импактом десяток винтиков и закрутить обратно? Как снять шкив с этого мотора? Он там на резьбе или на горячей посадке?
I'm wondering why you removed the 6 belt tensioner screws. The belt can be removed by rotating the belt on the spindles while pulling it off of the rear spindle. Not only that but I'm pretty sure the motor is easily removed without ever touching those 6 belt tightening screws. Re-installing the belt is fairly easy again by just putting it on the upper spindle and then starting it on the rear while rotating the belt. I'm sure it will work by either method.
Nice, simple. Thank you !
Nice work ☺
@@benedictjaziel7570 how did this happen
Is it possible to take the belt pulley off the armature and replace just the bearing? Thanks
Yes it is. You will need a puller to get the bearing off and possibly also for the pulley.
Which armature will fit a dewalt 718 type 3 ?
Any information on how to remove the pulley on the armature to replace the bearing?
Did you ever figure it out? I'm currently trying to do the same thing. There are no videos on youtube for it...
@@stephenharris6769 yep. Heat it up a while with a torch and it should come off pretty easily. Same thing for install. Heat it up and slide it back on. good luck! I mangled my original before learning this and had to get a replacement.
@@jaredhankee6515 Thanks man!
Блин, серьезно? Все видео сводится к тому как открутить импактом десяток винтиков и закрутить обратно? Как снять шкив с этого мотора? Он там на резьбе или на горячей посадке?
👍
I'm wondering why you removed the 6 belt tensioner screws. The belt can be removed by rotating the belt on the spindles while pulling it off of the rear spindle. Not only that but I'm pretty sure the motor is easily removed without ever touching those 6 belt tightening screws. Re-installing the belt is fairly easy again by just putting it on the upper spindle and then starting it on the rear while rotating the belt. I'm sure it will work by either method.
You obviously don’t know what you’re talking about and have never done this kind of repair to the saw!