SunLu S9 Plus unboxing, assembly, and first print
HTML-код
- Опубликовано: 18 сен 2024
- I unbox, assemble, and print on my new SunLu S9 Plus.
Its presently 55% off and one cannot get any other printer with that bed size and these features for remotely the same price.
a.co/d/fUM39vZ
I used a custom Cura profile that I just added the CR-10 gcode to but I bet a CR-10 Cura 5 profile would work just fine for this printer.
I saw where you mentioned you weren't sure if it prints petg, I'm assuming it did?
it is so far. after a bunch of prints I'll examine the boden tube to see if its melting. if it is, I need to look into a bi-metal heat-break to prevent the transfer of heat.
I ended up getting the bi-metal heat break and its been happily printing PETG without odd odors for awhile now.
So would you buy it again?
I totally did. Was lucky enough to pull the trigger before they ran out of stock. Went back for a third later and they were all gone.