I have a double-layer elliptical diamatic dome space truss and have imported the dxf file to SAP, and I am confused about how to load it. Should I calculate wind load or SAP is capable of that? I think dead, snow loads should be computed by hands and applied to each joints/nodes?
It is an useful video guide! I found a new style of truss for pre-engineering house, new skills in modeling as well. Thanks so much teacher.
thank for your comment,
Thank you so much. Please, is there a reason why releases are not included in the truss? Thank sir
Thanks for your tutorials, helpful
Thank you for support and pls help to share if it's useful
I have a double-layer elliptical diamatic dome space truss and have imported the dxf file to SAP, and I am confused about how to load it. Should I calculate wind load or SAP is capable of that? I think dead, snow loads should be computed by hands and applied to each joints/nodes?
how about purlin design?
The section is not shone after run...
DEAR SIR I SAW ALL OF K ,L FACTOR MAJOR AND MINOR IS = 1 , IN TRUSS DESIGN , IS THIS CONSERVATIVE ? thank you very much for tutorial ..
hi, I want to analyze a triangularvarch truss. but I after importing a dxf file to sap2000. It is not shown. what can be the problem ?
Why this truss No apply Wind load?
Yes sir, in this case of modeling, we do not include wind load case in this video,
thanks for comment
Please like and share Facebook Page: CSI ETABS Civil Engineer to get more videos tutorials
bit.ly/2mOpD7t