HOW TO INSTALL A DEATSCHWERKS DW400 FUEL PUMP IN A FORD F150 | My 2014 Ecoboosts DW400 In-Tank Pump!
HTML-код
- Опубликовано: 20 июл 2024
- Installed my new DeatschWerks DW400 LPFP in my 2014 F150 EcoBoost! And learned how to remove the bed on my F150 at the same time! This DW400 Mod helped me get more fuel to the engine during low RPM High load conditions. Normally wouldn't need this running Pump gas but on my full E85 tune we needed just a bit more fuel delivery to the XDI-35 HPFP at low RPMs. Now that its in, I am good to go with all and anything fuel system related! Unless I decide to fully build my truck in the future!
**DISCLAIMER**: This video and description contains AFFILIATED LINKS, which means that if you click on and make a purchase with one of the product links below, I may or may not receive a small commission.
Parts Used:
DeatschWerks DW400 for 09-14 F150 - ebay.us/wZ4Jmh
LIKE & SUBSCRIBE!! More to come!!! TURN ON THAT BELL notification so you don't miss any upcoming How To Videos & Upgrades to my F150 EcoBeast
E85 PR-X TEST n TUNE 1/4mi Run with Dragy! • 2014 F150 ECOBOOST SCR...
XtremeDI-35 HPFP INSTALL
• HOW TO INSTALL XDI-HPF...
CHECK OUT other Vids F150 ECOBOOST PLAYLIST: • MY F150 ECOBOOST
FOLLOW ME on Instagram: / everythingavron
ADD ME on Facebook: TheEverythingAvron
LIKE & COMMENT BELOW! Always open to ideas and feedback on what Mods you want to see next! Авто/Мото
Thank you, you help me install same pump on 2012 f150
I had to drop the tank because I have short box what a pain!
Great job
Great Helper
Great video and great job! I was thinking of dropping the tank but I like this method better! Word of caution though, I was always told to use nonsparking tools (like brass) when removing fuel sending units. One spark with a metal bar or hammer could be disastrous! Keep up the great work!
Very clean installation
Thanks 👍... it was a fun project too!
Man you’re a badass with your truck!
Use a bent electrical flat head screwdriver for the red connects on the harnesses !
Thanks bro! more to come for the EcoBeast!! and I will for sure try that... I literally HATE HATE those dang red clips!
how do you know how deep to set the pump, so that the sock is on the bottom, but not crushed?
The camera makes it look like the bed wasn’t 2 million lbs 😂
Why didn't you get the Walbro 450 or 525?
I get free Re-Tunes with MPT Performance if I buy through them, and they only had these DW400 kits. lol
The main pump is the HPFP, thats the big limiting factor when you upgrade turbos or turn up the boost..... if you plan on going Stage 4 or Stage 5 Turbos. Id say invest in the XDI-60 HPFP rather than the XDI-35.
Great video and great job! I was thinking of dropping the tank but I like this method better! Word of caution though, I was always told to use nonsparking tools (like brass) when removing fuel sending units. One spark with a metal bar or hammer could be disastrous! Keep up the great work!