manual G coding first half

[@ukmwg]

Hi John, check again your description of G00 at about 5mins 20secs, you state G90 in the audio which may be confusing for students.

[@adamwest7177]

love it, this is very well the missing peice I need to hang in there at work.. hard work goes a long way

[@anilskumar3577]

why didnt you assign value to z ?(while doing linear interpolation) we need value for depth of cut right?

[@dgengineers]

Can't illustrate in paper

[@chucklaurendeau1401]

Thanks, very helpful.

[@DundoMarinko]

Thank you for the lesson for beginner is well made ,

[@jiiji750]

this was helpful , thank you . could you do more videos :)

[@Halljac]

So what is the reasoning for these new videos? Part of the new freshman curriculum?

[@rlwd0164]

You are talking about G90 while you are at G00, really confusing. two completely different situations.

[@mamdouhnoshy8293]

G00 is the rapid moving position of the CNC table (X&Y), before either G90 or G91

[@testhossam1]

why using paper why not using direct screen capture and speed up the slow way if writing!

[@denimdragon]

5:40 = fail

[@aaronacj]

denimdragon du done