How to make etching prints using Tetra Pak

Поделиться
HTML-код
  • Опубликовано: 15 июл 2024

Комментарии • 10

  • @sjoschall
    @sjoschall 4 месяца назад +1

    It turned out so nice! Thank you for the demonstrating this printing technique. :)

  • @maggiefreeman6513
    @maggiefreeman6513 5 месяцев назад +1

    Great demo. Thank you.

  • @laymuuna8821
    @laymuuna8821 2 года назад +1

    Great! Thank you for showing us this wonderful artwork👌🏻🌻

  • @MultiCamillaaaa
    @MultiCamillaaaa 2 месяца назад

    Thank you very much ❤🙏

  • @lynneglazzard5910
    @lynneglazzard5910 3 года назад +6

    I agree, the info was good but the audio is terrible

    • @lobstermash
      @lobstermash 3 месяца назад +1

      Yes - don't turn away from the mike. Enjoyed the vid.

  • @kstutz230
    @kstutz230 Год назад +1

    Thank you. Helped me a lot! Did you make the cork needle?

  • @judithmoore8692
    @judithmoore8692 3 года назад +4

    Gave 👍🏻for good topic and instruction. 😄. Gave 👎 for poor audio quality. Some instruction faded out; could not understand some instructions, unclear voice.

  • @BoringStranger
    @BoringStranger 6 месяцев назад

    Why does the paper need to be damp?

    • @unusualartsourcingcompany6774
      @unusualartsourcingcompany6774  6 месяцев назад +1

      hello, if the paper is damp then it will accept the ink better and yiu will get a better print. However, make sure it isn't too wet or the print will be blurred. It's best to dip the paper in a tray of water, hold it up so any excess water runs off the surface and then pat it with paper towel and use in about 10 minutes