Hi Rico, Thank you for sharing this video! Your demonstration of the external compressor working with the internal low pressure air assist in the Mira 7 is very informative and helpful. Could you please share which smart solenoid you used in your Mira 7 laser? Also, where did you purchase it? Thanks again for the great video!
Hi yavorrev128, Thank you so much for watching my video!! Much appreciated! The smart solenoid is built into the Mira 7 Laster... It came with the laser!! Hope this helps! Have a great day! Rico
@@yavorroev128 Hey Again, I must have gotten lucky with my laser that was delivered 2 months ago.... You might want to reach out to the AEON support and ask them if that is a part you can purchase and install... Good luck. Rico
Interesting... still thinking about buying a laser. Is the external compressor recommended by the manufacturer or are you just wanting to extend the lifetime of the internal one?
Hello HP, The external compressor is not recommended but encouraged. If you look at my video berfore this one... it will show you why you should install one. the external compressor will blow higher pressure (25psi) over your cut piece virtually eliminating scarring, charring and burning on the top surface of your material. This will eliminate the need to mask your material. Masking takes time and money. so in the long run you will make it all back@ thanks for watching... Rico
Hi Rico,
Thank you for sharing this video! Your demonstration of the external compressor working with the internal low pressure air assist in the Mira 7 is very informative and helpful.
Could you please share which smart solenoid you used in your Mira 7 laser? Also, where did you purchase it?
Thanks again for the great video!
Hi yavorrev128,
Thank you so much for watching my video!! Much appreciated!
The smart solenoid is built into the Mira 7 Laster... It came with the laser!!
Hope this helps! Have a great day!
Rico
@@ricohernandez2394 Thank you!
But my Mira 7 (manufactured 2023) doesn't have one ☺
@@yavorroev128 Hey Again, I must have gotten lucky with my laser that was delivered 2 months ago.... You might want to reach out to the AEON support and ask them if that is a part you can purchase and install... Good luck.
Rico
@@ricohernandez2394 Thanks!
I will do it.
Interesting... still thinking about buying a laser. Is the external compressor recommended by the manufacturer or are you just wanting to extend the lifetime of the internal one?
Hello HP,
The external compressor is not recommended but encouraged. If you look at my video berfore this one... it will show you why you should install one.
the external compressor will blow higher pressure (25psi) over your cut piece virtually eliminating scarring, charring and burning on the top surface of your material. This will eliminate the need to mask your material. Masking takes time and money. so in the long run you will make it all back@
thanks for watching...
Rico