Hei Mr Renatas. Thanks for the video. I have a problem with my bravo clima, after 30 minutes of ac, but after no air is coming from the vents, i ve changed the electric fan, actuators and the ac compressor. Pls help. Thank You.
Thanks for the answer. Please search this : hello-fiat-bravo-2-1-4-66kw-clima-problem-auto-air-conditioning-system-not-working , but for this fix , it was another problem. But i have this now, no air from vents, if i reset it it works for sometime, please post there on ff uk if you find any lead on how to repair - no air coming from the vents- Thanks BogdanGeorge
Sh*t .... Thanks for the informative video and the luck. We just duscovered this issue today. Time for a deep dive into this area of Fiat maintenance. 😂 😢
Hi, in my Delta III (basically a Fiat Bravo) I have the problem the climate control is only getting cold when I set the temp to 16 degrees or lower. Even @16 degrees it's a bit warm. Is this also caused by the plastic parts? And I guess with LHD I'd find the motors on the passenger side? Thanks!
Excellent work... But why everyone else completely take off the dashboard? There isn't good enough access to remove them.?i have even see some people to cut off a bit to gain access.
Hi I have a Fiat 500 changed the heater matrix and since I have I have to bang the side of the dash for it to blow hot air is this what could be causing it , or I can mess with the buttons and sometimes it works
Hi, sorry for my english, is not my language :( I have the same problem but not in passenger side, i have this problem on driver side Both eletcric motors are in passenger side? (both i mean motor for passenger side and motor for driver side) Or i need to remove panel from driver side, under steering wheel? I hope you understand what i try to say :D Thank You very much!
Hi thanks for the vid. Would this be the same if my heaters are blowing cold even though the engine is hot, I’ve checked the anti freeze as I’ve changed water pump and thermostat and bled system but still blowing cold air. Look forward to your reply
I’ve also noticed on a lot of forums as I’ve been scratching my head with it all. That there is a grave in the uk that puts a self tap screw through them, but from your vid it looks just as good to replace the plastic clips rather than drilling through the spindle. Or ive got confused with other issues
@@buddylee4177 to check it is obvious, one side changes temperature other side doesnt if there one side flap not working. Ad there are possibility that main flap got stuck then both sides stays on same temp.
Repost but with better english :) Hi, sorry for my bad english, I am not a native speaker :( I have the same problem but not on the side of the passenger, but on the driver side. I was wondering if both electric motors (passenger side + driver side) are on the side of the passenger? Or do I need to remove panel from driver side under steering wheel? I hope you can understand what I am trying yo tell you :D Thank u very much!
very helpful demo there,its good to know that i dont have to bring down the whole dash ,as some are doing, however my car has a similar issue but slightly different , the passanger side vents only blowing cold air despite setting the temperature high, however the driver side am getting hot air but on ly at the winscreen vent, the center vent seem to be blocked even though i can feel the hot air trying to sneak out. what do you think i need to look at. thanks
fred matubia I head exactly same problem as yours. There are 6 mentioned in video plastic parts. I replaced 3 and everything worked perfectly since. Good luck
![Stromae, Pomme - “Ma Meilleure Ennemie” (from Arcane Season 2) [Official Visualizer]](http://i.ytimg.com/vi/1F3OGIFnW1k/mqdefault.jpg)
Where you bought spare parts, caps that go on the engine?
Hei Mr Renatas. Thanks for the video. I have a problem with my bravo clima, after 30 minutes of ac, but after no air is coming from the vents, i ve changed the electric fan, actuators and the ac compressor. Pls help. Thank You.
@@bogdangeorge7881 Hi Unfortunately I can’t suggest the answer. I newer experience this problem. Sorry and good luck.
@@MrBuinickas
Thanks for the answer. Please search this : hello-fiat-bravo-2-1-4-66kw-clima-problem-auto-air-conditioning-system-not-working , but for this fix , it was another problem. But i have this now, no air from vents, if i reset it it works for sometime, please post there on ff uk if you find any lead on how to repair - no air coming from the vents- Thanks BogdanGeorge
That is the easy two to replace, try replacing the recirculation door one without taking the dash out.
Is it even possible? without the dash out job?
Sh*t ....
Thanks for the informative video and the luck.
We just duscovered this issue today. Time for a deep dive into this area of Fiat maintenance. 😂 😢
Hi great video
Do you know where can I get this work done in London?
Hi Any garage. Show them my video. regards
Hi, in my Delta III (basically a Fiat Bravo) I have the problem the climate control is only getting cold when I set the temp to 16 degrees or lower. Even @16 degrees it's a bit warm. Is this also caused by the plastic parts? And I guess with LHD I'd find the motors on the passenger side? Thanks!
Excellent work...
But why everyone else completely take off the dashboard? There isn't good enough access to remove them.?i have even see some people to cut off a bit to gain access.
Hi no not at all There are plenty of room for this job to get done. Good luck
Hi I have a Fiat 500 changed the heater matrix and since I have I have to bang the side of the dash for it to blow hot air is this what could be causing it , or I can mess with the buttons and sometimes it works
Hi Sounds like you have bad blower motor or its connection. Good luck
Hi, sorry for my english, is not my language :(
I have the same problem but not in passenger side, i have this problem on driver side
Both eletcric motors are in passenger side? (both i mean motor for passenger side and motor for driver side)
Or i need to remove panel from driver side, under steering wheel?
I hope you understand what i try to say :D
Thank You very much!
Hi thanks for the vid. Would this be the same if my heaters are blowing cold even though the engine is hot, I’ve checked the anti freeze as I’ve changed water pump and thermostat and bled system but still blowing cold air. Look forward to your reply
Hi Yes you have exactly that problem. The flaps are not moving. Regards
@@MrBuinickas thank you for such a quick response is there a way to check this
I’ve also noticed on a lot of forums as I’ve been scratching my head with it all. That there is a grave in the uk that puts a self tap screw through them, but from your vid it looks just as good to replace the plastic clips rather than drilling through the spindle. Or ive got confused with other issues
@@buddylee4177 to check it is obvious, one side changes temperature other side doesnt if there one side flap not working. Ad there are possibility that main flap got stuck then both sides stays on same temp.
@@buddylee4177 I'm sorry but I can't comment on that, I don't realy understand what you realy mean.
Repost but with better english :)
Hi, sorry for my bad english, I am not a native speaker :(
I have the same problem but not on the side of the passenger, but on the driver side.
I was wondering if both electric motors (passenger side + driver side) are on the side of the passenger?
Or do I need to remove panel from driver side under steering wheel?
I hope you can understand what I am trying yo tell you :D
Thank u very much!
Hi Yes both motors (in fact 3 motors) are on the same side. Regards
@@MrBuinickas Thank you very much for info :D
very helpful demo there,its good to know that i dont have to bring down the whole dash ,as some are doing, however my car has a similar issue but slightly different , the passanger side vents only blowing cold air despite setting the temperature high, however the driver side am getting hot air but on ly at the winscreen vent, the center vent seem to be blocked even though i can feel the hot air trying to sneak out. what do you think i need to look at. thanks
fred matubia I head exactly same problem as yours. There are 6 mentioned in video plastic parts. I replaced 3 and everything worked perfectly since. Good luck
Is this same on a 500l
@@Mrjim.rockford no, don’t think so.
After you put the motors
Did you do some kind of reset?
Hi John No reset or other manipulation is needed. Installing and enjoying. Regards
@@MrBuinickas Thank you!
this is a right wheel drive car, right? so is it the same to fix it with a left wheel drive car? i dont think so... i am wrong?
john michalopoulos Should be exactly the same. Regardless location of drivers position.
EXCELLENT!