Reassemble a Porsche 911 F & G body 911 door handle, latch, window regulator, felt and window guides

Inside the 911 door is a work of “perfect clank when closed” art.
To get everything working correctly there is a sequence of events that you need to reassemble the parts in, for the puzzle to fit.
Here are my steps and a quick video to show you.
1. Outer door felt. Use pliers to push the clips into the holes
2. Connect latch rods for the lock and the internal handle to the latch
3. Install the latch with the single screw facing up. Wiggle the latch though the hole in the door to get it in.
4. Route the rods tor the lock and door pull through the rubber guides into the door metal. Bolt down the door lock swivel after you put the threaded rod into the door grommet for the lock plastic.
5. Put the window regulator down (horizontal in nature) in through the large slot at the bottom of the door.
6. Feed the glass with the left mechanism inside the door and put it at an angle so you can slide the window guides onto the regulator.
7. Mount the regulator where it needs to be and the glass will follow.
8. Slide in the front vent window if you have a targa, then slide the rear guide in or the single glass window frame for normal tops. Loosely tighten until you install so you can get the proper angle orientation.
9. Roll the window up and install the door handle from the outside. Press down on the V mechanism to fit it over the door lock peg.
10. Tighten everything up once you check the window glass angles. You can tighten the glass to the body by adjusting the frame.
11. Install the inner door window felt toward the inside so it touches the glass and then install the vapor barrier and door panels.
Thanks for watching!