Good job on the video bud, but got 1 suggestion...at around 5:12 when you show how to zero the unit, you actually demonstrate 1/2 of how to zero the unit when off of a stand/without a stand. When the bars pop up on the screen like that you're supposed to lift the ass of the bike up to full droop, then set back down on the ground and it will recalibrate itself to read static/free sag. I just read the instructions again & technically you're not wrong because, but there is an easier way to zero the unit if you have a center stand: once powered on & clipped to the fender while on the stand, power on the unit & press the power button to recalibrate. Your vids look way better than mine, just throwing some info out there. Thanks & again good job 🤙🏻
Just got mine today & super stoked about it. Only problem so far is that I opted to use my cell (Android) and thought that you had to pair the unit via Bluetooth manually like a speaker or headphones or something. Still not quite sure how I did it, but think you just have to do the following: 1. Turn on Bluetooth & GPS on your phone 2. Launch the app & enable it to read your location & it pairs automatically I was putting the Slacker in pairing mode but apparently that's only for pairing their remote to the unit. The instructions suck in that regard.
Just got around to trying my new one out and remembered it doesn't stick to a Ti rear axle. Just a note for anybody with one of those, I machined a steel plug to fit inside the axle while I measure and then I put it back in the box with the unit.
Good job on the video bud, but got 1 suggestion...at around 5:12 when you show how to zero the unit, you actually demonstrate 1/2 of how to zero the unit when off of a stand/without a stand. When the bars pop up on the screen like that you're supposed to lift the ass of the bike up to full droop, then set back down on the ground and it will recalibrate itself to read static/free sag. I just read the instructions again & technically you're not wrong because, but there is an easier way to zero the unit if you have a center stand: once powered on & clipped to the fender while on the stand, power on the unit & press the power button to recalibrate. Your vids look way better than mine, just throwing some info out there. Thanks & again good job 🤙🏻
Just got mine today & super stoked about it. Only problem so far is that I opted to use my cell (Android) and thought that you had to pair the unit via Bluetooth manually like a speaker or headphones or something. Still not quite sure how I did it, but think you just have to do the following:
1. Turn on Bluetooth & GPS on your phone
2. Launch the app & enable it to read your location & it pairs automatically
I was putting the Slacker in pairing mode but apparently that's only for pairing their remote to the unit. The instructions suck in that regard.
Totally agree!
Just got around to trying my new one out and remembered it doesn't stick to a Ti rear axle. Just a note for anybody with one of those, I machined a steel plug to fit inside the axle while I measure and then I put it back in the box with the unit.
Great point! and great solution! Thanks!
It wont pair