K24 Swap BRZ Part 8 Ep. 2 - CD009 Throw-out Bearing, Clutch Fork, and Clutch Cylinder Replacement

[@andrew_clare]

Thanks so much for this video and the link for the new parts! I was struggling HARD to get a throw out bearing kit here in Europe 😅

[@Vgk36]

Man this video needs to have a million hits. SUPER clear conicse to thr point and excellent lighting and explanation.
10/10.
Randomly ran across this while looking for fhe internal slave trans that 350's have .
My new to me g35 has a cd09 . But ive never see thr other version. Great video and new sub !

[@nbdxchance9010]

Great vid. I can hear my throw out bearing sometimes at idle. Going to have to replace it soon.

[@mr_chliken9088]

Dude I found you in a comment section, your videos are super high quality and I hope you go somewhere!! Also the k24 brz is crazy 😂

[@ObeyBrandon2]

Thanks man! I’m doing a CD00A swap on my s2k, this helped a lot for changing my bearing and pivot ball!

[@BuildingWithSean]

Glad you found it helpful!!

[@ObeyBrandon2]

@@BuildingWithSean btw how did you know the m8 bolt is 35mm long

[@BuildingWithSean]

@@ObeyBrandon2 I believe that was the spec of the bolt, but honestly I could have just measure it with calipers.

[@niicks_z]

Thank you for this vid , helped out a bunch 🤝🏼

[@robmartinez6768]

Great video, man, very detailed only one question ( is seating the bearing like that safe?)

[@Thisiskrio]

As long as it’s flush you won’t have a problem, just make sure it’s going on STRAIGHT, same thing would go w a press

[@Frank_Karbo]

Suuuper helpful thanks !

[@blisssarchive]

what kind of grease did you use

[@dronin5937]

Thanks brutha