Thanks! I used Fusion 360 to design them. Piece A has the bump to press the leather over and piece B has the hole in it. There is also a 3mm gap between the bump and the hole so that I do not give the leather the texture of the 3d print. It is important to put a curve on the corner where the piece B hole touches piece A. This is to prevent piece B from scratching your leather when you press it. Printed with PLA and a layer height of 0.16mm with 30% infill. I think I would do more infill if I made the pieces any bigger.
This is really, really impressive.
Thanks! It was so much fun to make!
This is awesome good job
Thanks! Glad you enjoyed it!
Super cute!!
Thanks! It was a lot of fun to make!
wonderful job I Iike to know some more about 3D module
Thanks! I used Fusion 360 to design them. Piece A has the bump to press the leather over and piece B has the hole in it. There is also a 3mm gap between the bump and the hole so that I do not give the leather the texture of the 3d print. It is important to put a curve on the corner where the piece B hole touches piece A. This is to prevent piece B from scratching your leather when you press it.
Printed with PLA and a layer height of 0.16mm with 30% infill. I think I would do more infill if I made the pieces any bigger.