hey! so I film the builds that customers purchase so we would need someone to but a set from us. but here's a kit option ntxglow.com/products/honda-prelude-bb6-complete-diy-kit
turn and reverse are there on the module and wired up but its impossible for me to wire them up on the back of the tail light assemblies. so the wires are there but the customer will have to wire them to the bumper lights for reverse and turn signal
@@zaccook Got it, question...this may not be related to this build but im trying to build my own board and had thoughts on which resistor to put for my turn signals and reverse leds. Would these be 12v regulated or non?
this one is slightly cheaper, I have never used it but next level neo very reputable www.nextlevelneo.com/products/color-flow-led-controller-w-sequential-drl-and-turn-inputs
![Building a TESLA SWAPPED 350Z in 27 minutes! [COMPLETE TRANSFORMATION]](http://i.ytimg.com/vi/G1OgwcWsjVA/mqdefault.jpg)
Love how you show your mistakes. Gives beginners like me hope and shows us everything is correctable
Thanks! I mess up builds ALL the time haha
how can I make the 5mm holes, I was thinks of making them with a 5mm drilller, but then I need the holes molds to not to mistake.
Will you please make a video for a 97' Honda Prelude's Tail Lights? I'm trying to make my own for my Lude. If not could you direct me to a kit?
hey! so I film the builds that customers purchase so we would need someone to but a set from us.
but here's a kit option ntxglow.com/products/honda-prelude-bb6-complete-diy-kit
Couldn't you have used a heater of some sort to heat the board to a point that it would have bent without breaking?
So only red for brake will be active on these tails? No turn signals or reverse?
turn and reverse are there on the module and wired up but its impossible for me to wire them up on the back of the tail light assemblies. so the wires are there but the customer will have to wire them to the bumper lights for reverse and turn signal
@@zaccook Got it, question...this may not be related to this build but im trying to build my own board and had thoughts on which resistor to put for my turn signals and reverse leds. Would these be 12v regulated or non?
its no need to use resistor for led ?
how are you guys getting these boards that hold the LEDS? I know you can buy them but how are the conformed to fit correctly?
Ive got the boards on my site actually! ntxglow.com
Blue ghozt is expensive
Please suggest a budget controller..
Let me get back with you on that
this one is slightly cheaper, I have never used it but next level neo very reputable www.nextlevelneo.com/products/color-flow-led-controller-w-sequential-drl-and-turn-inputs
Please suggest a 30 bucks board
@@asifibz1389Bruh
What configuration in blue ghost app? Is it matrix or just strip?
this was still set up as strip, I need to mess with the matrix setting to see the difference. had to hustle to get the video up haha
what the name plastic black plate sir…
illumaesthic diy kit
How much would this cost all fully built?
if you just used your stock tails maybe 450 at best
goated
Brother plz intall biker back pack eyes in toyota corola headlite are honda civic pls pls pls
i have everything i need to start making lights but the dang ultrasonic cutter 😭
For sure not needed! Start with a dremel and make sure you like building lights before dropping the cash
Tanks prou fans from Maroc 🙏🫡🇲🇦