So pin1 is output to LED on the upper side of the pcb and at the same time output to pin in JST-XH connector right? and what is distance between each pair of sensor for best result? Your diagram is a bit blurry.
@@EDISON_SCIENCE_CORNER Thank you for replying. I already get that part. I mean pin 1 of LM358 is output to LED labeled "LED5 0805" and same output is connected to one of the middles pin in JST-XH. Is that correct?
😍🤩
need gerber file
Yes
So pin1 is output to LED on the upper side of the pcb and at the same time output to pin in JST-XH connector right?
and what is distance between each pair of sensor for best result?
Your diagram is a bit blurry.
The first pin is 5v the last pin is gnd. Middle pins are outputs. Please send me an email for the circuit diagram
@@EDISON_SCIENCE_CORNER Thank you for replying.
I already get that part. I mean pin 1 of LM358 is output to LED labeled "LED5 0805" and same output is connected to one of the middles pin in JST-XH. Is that correct?
where is the schematic diagram
edisonsciencecorner.blogspot.com/2023/10/diy-line-sensor-array-for-line-follower.html
sir can you provide this gerber file?
No
@@EDISON_SCIENCE_CORNER i'm form other country, that's why i asked you..if you can provide it's will good, otherwise wise best wishes for you 😊😊😊
Can you give me the pcb for the line follower
I live in srilanka
And I commented on the line follower video
Yes
Schematic please 😌
edisonsciencecorner.blogspot.com/2023/10/diy-line-sensor-array-for-line-follower.html
❤🎉
💎