How To Install The Graco® Turn2Me™ 3-in-1 Car Seat Forward-Facing using the Vehicle Seat Belt

#convertiblecarseat #carseatinstallation #bestinfantcarseat
Learn how to install the Graco Turn2Me 3-in-1 Car Seat forward-facing using the vehicle seat belt by following these easy steps. Before learning how to install your car seat, you will need to know how to use the car seats’ turn feature. The turn levers are located under each armrest, but you only need to use one to turn the seat. At the same time, squeeze the blue trigger and the grey lever and rotate the car seat. Once you hear a click when rotating your car seat, you will know that it is in the secure position. Remember that the turn feature can only be used when in rear-facing mode. After removing infant inserts and making sure your convertible car seat is rotated in the forward-facing position, unhook the tether strap and place it in your car seat. Recline the 3-in-1 car seat using the actuator to one of the four forward-facing positions.
Place the forward-facing car seat in the back of your vehicle. Take the tether strap behind the car seat and under the headrest. Expose the forward-facing belt path by raising the headrest to the highest position and undoing the snaps on the seat pad. Open the SnugLock lock off with the grey lever. Route the seatbelt through the forward-facing belt path then buckle your seatbelt. Remove slack and feed it to the retractor, and then close the Snuglock lock-off. Reattach the snaps on the seat pad, lower your head rest, then attach and tighten your tether. Finally check for tightness and adjust harness height accordingly for baby.
Want to learn more about the Graco Turn2Me 3-in-1 Car Seat? Visit us: www.gracobaby.com/car-seats/t...
Want to learn about Graco’s car seat safety standards? Visit us: www.gracobaby.com/safety.html
#carseatinstallation
#convertiblecarseat
#bestinfantcarseat
#gracocarseat