Voron 2.4 R2 Build Guide: A DIY Monster! Voron Assembly - Part 6 - Installing the Bed

[@JohnStruemph]

Good stuff!

[@minimal3dp]

Thanks

[@oscarvogel2140]

I think eventually you will have to get it put together and get it moving to find where the z endstop goes, before finding out where the bed goes. So bed is probably one of the last things to install. Unless maybe if you are using tap.

[@minimal3dp]

I will eventually get it together.

[@oscarvogel2140]

@@minimal3dp Took me almost a year and I'm about to push my first plastic. Sooo tap or what are you going to use for z endstop?

[@minimal3dp]

@@oscarvogel2140 I am going with the Tap. It came with the Kit

[@ellwoodgrumblefart2065]

Hi Mike, did you tigten the screw from the bed heater? You shoud do this, it's a live saver.
Greetings Ellwood

[@ellwoodgrumblefart2065]

I ment the ground screw from bed heater.... 😂

[@minimal3dp]

Thanks for the heads up. I will verify that I did tighten it.

[@ellwoodgrumblefart2065]

@@minimal3dp 👍 greetings from germany

[@keithdrake8253]

Thanks for the video... I have a Geeetech A30m which has a 320x320 build plate... How hard would it be to use that build plate in a 350 Voron 2.4 build?

[@minimal3dp]

It's probably not easy. The holes will not line up. You should research it more. There might be some mods.