Can you help me with what parameters to make the start and stop maintained with a momentary contact. I am using a wireless remote on a turning roll. The remote has a on and an off button and a forward and reverse button all momentary. Like on a crane remote.I need the forward or reverse to stay latched in on a momentary forward/ reverse push button. Thanks for the infomative videos .
Can we able configuration digital input to fault reset with drive relay? Is it possible? When fault accoured does configuration do reset automatically?
Ran across a PF 4 that would not let me access the Advanced parameters above A101 so it was impossible to assign the correct RS-485 address to it. A Rockwell tech once told me how to get those parameters turned back on but darned if I can remember. Do you know this publicly undocumented issue? I'm sure there's internal Rockwell help available if you're rich enough for a subscription :(
Thank you so much buddy.
I finally got my powerflex 4m to run my 3 phase motor - after several weeks and other videos.
Thank you.
Can you help me with what parameters to make the start and stop maintained with a momentary contact. I am using a wireless remote on a turning roll. The remote has a on and an off button and a forward and reverse button all momentary. Like on a crane remote.I need the forward or reverse to stay latched in on a momentary forward/ reverse push button. Thanks for the infomative videos .
Can we able configuration digital input to fault reset with drive relay? Is it possible? When fault accoured does configuration do reset automatically?
Whats the difference between 3 wire and 2 wire control?
Ran across a PF 4 that would not let me access the Advanced parameters above A101 so it was impossible to assign the correct RS-485 address to it. A Rockwell tech once told me how to get those parameters turned back on but darned if I can remember. Do you know this publicly undocumented issue? I'm sure there's internal Rockwell help available if you're rich enough for a subscription :(
devo collegare inverter con una scheda per caldaia biomassa