I thought that Torque wrenches were supposed to be not used for loosening as it could upset the calibration, it is printed on the wrench. Scaffy bar on a toeque wrench?
No instruction on winding the piston back into the caliper and no information on the torque setting for the rear hub nut. Using a length of scaffold pole to tighten the hub nut. ARE YOU SURE???
friend could you make a video on how to check the hoses and vacuum valve, I have a 308thp and I think I am failing (p0299) or maybe it is the turbo actuator I do not know. great videos crack
Depends on size. The one with a 36mm nut needs to be 300N/M but the version with a 32mm nut should be 210N/M. You should only use copper grease around the brakes but specific slider lube/grease for the sliders. When you watch the part of the video with him wire brushing the axle stub beware of damaging the small black plastic ABS sensor.
I thought that Torque wrenches were supposed to be not used for loosening as it could upset the calibration, it is printed on the wrench. Scaffy bar on a toeque wrench?
Should have used a breaker bar.
Is the electronic reset necessary? Have seen similar cars done without this?
Hi where did you get the little rubber support that you put on the jack and do you have a name for it and link thanks
Will this be the same brake set up as a citreon ds3
muito bom o serviço meu caro.. parabéns.
No instruction on winding the piston back into the caliper and no information on the torque setting for the rear hub nut.
Using a length of scaffold pole to tighten the hub nut. ARE YOU SURE???
friend could you make a video on how to check the hoses and vacuum valve, I have a 308thp and I think I am failing (p0299) or maybe it is the turbo actuator I do not know. great videos crack
@Nigasan Koneswaran and where is the seesaw?
Bedankt voor de nuttige video, waar heb je de nieuwe asmoer en stofkap gekocht :)?
Please tell me tightening force of the screw securing the discs and kind of grease that used.
Depends on size. The one with a 36mm nut needs to be 300N/M but the version with a 32mm nut should be 210N/M. You should only use copper grease around the brakes but specific slider lube/grease for the sliders. When you watch the part of the video with him wire brushing the axle stub beware of damaging the small black plastic ABS sensor.
thank u
Tragedie!!!
Some take 32mm socket to remove the hub nut and that isn’t how you torque up the hub nut.🫢