When I was in the motor trade, sticking clutches often happened after storage! The best way to free the clutch? First run the engine until it worms up. 2nd, jack up one rear wheel above the ground. Use solid axle stands. 3rd, select top gear siting on the seat and depress your clutch fully. 4th, with the clutch depressed: start your engine,!!! This works, due the backlash going throughout the gear train. Take it out of gear, You have just learned an old trick, which saves a lot of work/money. Enjoy 🔧🇬🇧😁
The best small rear wheel drive tractor ever made, and the most sold tractor model. Every part still available and at reasonable prices. With proper maintenance extremely reliable. As simple as can be.
Water goes in around the gear stick rubber and the hydraulic pump have a filter go through the side plate behind the pto lever have a look and you need to clean to top of the tractor down before lifting to to or you will get dirt in the tractor
SOMETIMES NOT EVEN THE PUMP. THE CLUTCH. ESPECIALLY 2 STAGE.. YOU HAVE TO MAKE SURE THE PTO IS TURNING AT REAR WITH FORCE..... I KNOW THIS IS A WHILE BACK THOUGH....... or WHAT WAS THE PROBLEM
When it comes to repairing tractors etc. nothing is more valuable than these kinds of videos. So, thanks to all these VERY helpful people.
When I was in the motor trade, sticking clutches often happened after storage!
The best way to free the clutch?
First run the engine until it worms up. 2nd, jack up one rear wheel above the ground. Use solid axle stands. 3rd, select top gear siting on the seat and depress your clutch fully.
4th, with the clutch depressed: start your engine,!!!
This works, due the backlash going throughout the gear train.
Take it out of gear, You have just learned an old trick, which saves a lot of work/money.
Enjoy 🔧🇬🇧😁
G
Thanks for taking your time to share this with us! :)
Hey Mary !
to much dirt around the work area.. one of the best tractors ever made. great rubber on it.
The best small rear wheel drive tractor ever made, and the most sold tractor model. Every part still available and at reasonable prices. With proper maintenance extremely reliable. As simple as can be.
I saw a small part fall as the lift cover was raised, I would of liked to see a chain block used to lift the cover.
the rubber boot on the shifter will let the water in and the dip stick to
Its the same with mf165???
Whay not start with clean arond the part you romowe....think lite...
I can not believe you took this dirty tractor apart.. Clean up the tractor then take it apart..
I work this aroud 24/7 And this is mint!!
The hillbilly way
Your wife did a great job
Good job sir 👌👍
Is there not something to disconnect before u lift the top off or is this the earlier 35,s and grey fergie s?
Water goes down wear the gear sticks are always the case
Buenas Noches
Me podrías enviar el tutorial l del desmonte de la Bomba Hidráulica del tres puntos del Massey Fergunson 290 por favor
Good with some dirt down the gearbox.
Yup, cleanliness is for sissies
Water goes in around the gear stick rubber and the hydraulic pump have a filter go through the side plate behind the pto lever have a look and you need to clean to top of the tractor down before lifting to to or you will get dirt in the tractor
At 7:20 i saw ,what I believe to be,the problem....anyone else?
What?
Condensation takes place just like in a fuel tank.
It would be awesome if we could see what your doing. 😂😂😂
SOMETIMES NOT EVEN THE PUMP. THE CLUTCH. ESPECIALLY 2 STAGE.. YOU HAVE TO MAKE SURE THE PTO IS TURNING AT REAR WITH FORCE.....
I KNOW THIS IS A WHILE BACK THOUGH.......
or
WHAT WAS THE PROBLEM
Moze li prevod na srpski jezik,hvala
dream on
tradusir a español gracias
Your hydraulic/hydraulic pump quit cause your oil was full of water.
les falta para ser mecanico
Bundy Bears Shed.
Your wife is fired
J
I saw a small part fall as the cover was raised, I would have liked to see a chain block used to lift cover.