Clever solution, looking at the setup you could try turning the bolts around so the rounded, more aqua dynamic, heads are on the bottom in the flow for reduced drag.
Are you zenus who already emailed or someone different? If you need the STLs send me an email. Otherwise with other parts they are self explanatory. Ie 316 stainless fastener etc
@BillaBong1 I just went to my local hardware supplier. All 316 fittings standard sizes Make sure to acetone before using double sided tape. Check torques after a few uses. Mine hasn’t budged since. Still good to check.
@@spoton6584 No issues at all. Boat has been on countless trips since. Haven't had to tighten up bolts or anything. Because not much UV. Low temps. PLA has been fine. Recently been using PetG and its got way more strength and not as brittle.
![Seungmin "그렇게, 천천히, 우리(As we are)" | [Stray Kids : SKZ-PLAYER]](http://i.ytimg.com/vi/kAzmhLHePqU/mqdefault.jpg)
Perfect solution
Thanks bud
Clever solution, looking at the setup you could try turning the bolts around so the rounded, more aqua dynamic, heads are on the bottom in the flow for reduced drag.
Yes great suggestion
Would you consider selling a kit or even just the washers? I’ll be happy to buy one from you! I don’t have a 3D printer. 😢
Haha thanks James, sorry I haven't thought about selling it. I'm sure someone in your network would have a 3D printer!
nice i was looking to do the same thing. good one👍
Thanks 👍
@@sailingkulali if you can could you please send me links to all the other items used in this installation?
Are you zenus who already emailed or someone different? If you need the STLs send me an email. Otherwise with other parts they are self explanatory. Ie 316 stainless fastener etc
@@sailingkulali yes its me lol just wanted to et the exact stuff youre using
@BillaBong1 I just went to my local hardware supplier.
All 316 fittings standard sizes
Make sure to acetone before using double sided tape.
Check torques after a few uses. Mine hasn’t budged since. Still good to check.
What material did you use in the 3D printer?
Pla
@@sailingkulali how is the pla holding up . I'd almost think petg would work great for this also.
Well done.
@@spoton6584 No issues at all. Boat has been on countless trips since. Haven't had to tighten up bolts or anything. Because not much UV. Low temps. PLA has been fine. Recently been using PetG and its got way more strength and not as brittle.
Where can I find your email address to ask for the stl? Thanks in advance!
In my profile. Otherwise put your email here and I’ll send it to you.
Sent
@alexc6408 👌