Complete Dash Removal 88-92 Mazda Mx-6 and 626, GD Chassis
HTML-код
- Опубликовано: 5 сен 2020
- A step by step how to on how to remove the dash on this 89 Mx-6 GT.
There are some differences between 88-89 and 90-92, as well as manual climate control cars as mentioned in the video.
On 90-92 Mx-6 and all 88-92 626, those cars have power seat belts so that is something to figure when removing the A pilar trim.
I am parting out this entire car so if you need anything, just let me know!
Don't forget to subscribe!
-Eric Авто/Мото
I own a Mazda 626 Sedan in Prestige Silver colour, 1990 model ... bought brand new in Melbourne, Australia as a gift from my father for my 18th birthday. He paid $32,000 Australian dollars for it back then! It's now 32 years old, has done 500,000 kilometres and l continue to drive it daily. Has never failed me. Unbelievable car. I cannot part with it. My first and so far, only car ...!!
People cant believe it.
Keeping the oil clean these cars can last a very long time. I drove my 90 626 for 25 years, and 400,000 miles, I then gave it to a friend. I did have to do the valve stem seals once. It was smoking a little on start up. I did the rope method so I didn't have to remove the head. Even at that many miles it did not burn any oil. Hard to go wrong with the Mazdas of this era, at least the ones with a manual transmission
I wasn't looking for another one, But when I saw a 89 MX-6 in great condition and 80,000 miles, I had to have it. Been driving it now daily for 3 years, and get positive comments where ever I go.
@@mikep4866 Just phenomenal Mike! I just purchased the new 2022 Mazda 3 sedan but am still keeping my 626 (will never let it go) and intend to drive both cars. Thankyou for sharing your fabulous story! Kind regards from Melbourne!
Eric, I love the MX-6's!!! My first car was a 1991 MX-6 manual. A couple years later I got a 1990 MX-6 - GT manual and fell in love with Turbos. Years later, when I wife and I were just married, I found a cherry 1989 MX-6 GT manual and we drove that car for about seven years. Hit two deer in it and fixed it my self both times. Tore the exhaust off and put a flowmaster were the cat was with a short pipe out in front of the rear tire. I traded that car for a old 22re pickup and miss her dearly. These Yotas are easy to find but that Mazda was special to me.
I'd love to see rust video of this car, there are many critical areas on these cars
A big help as Ive got to replace the heater core on my '90 wagon. Hi from down under! Subbed.
I had a '91 626. Regretted selling it ever since. So simple. So reliable.
My first car was a 91 626 in high school. it was only a 4 year old car. I regretted selling it so much that I bought an 88 MX-6 in 2022.
Hello, Great video on the complete dash removal! You indeed made it look easy! I do have a 1990 MX 6 (original owner) and my turn signal cancellation has just given out. Do you have instructions for fixing this?
Cool movie, and nice color on your 626!
Luv these cars I'm working on my 88 mx6 Gt. I'm putting a 60/63 trim, watermeth and a lot more goodies. I have a Zombie chip now but going in with a MS system
Hello iam from Nigeria and I have something exactly like that, I love. but I need some part to change like the driver side front turning lights door racks if possible the complete doors radiator fan dash cos mine is cracked so how do I get you
My first car was a 90 mx6 gt. Love that car!
great video. I need to replace the antenna mast on my 1992 Mx6 DX. Any help?
So, you wouldn’t happen to have a turbo setup with a manifold you would get rid of? I have an 89 626 I’m trying to turbo. Also, the cover on top of the full vent system the red part can you change that without removing the whole dash?
Hey! Great vid, im wondering, do you have a complete exhaust system for 91 mx6 gt.
Necesito ayuda...el marcador de la temperatura no me funciona.. cómo hacerlo funcionar
I guess we missed a couple bolts when we put that dash in there ~18 years ago.
Yep, I dont think we knew exactly what we were doing lol
Are you still parting them out cuz I have a 88 626 that needs a wiring harness for the cooling fan
I bought a ‘89 MX-6 GT brand new back then. Manual trans, turbo and every option except 4 wheel steering. Was my first new car after graduation from college and working at my first real job.
I loved the car, though I replaced all the cloth with leather, including the door panel cloth. I also had black MSW wheels before black wheels were cool. My favorite feature was the oscillating center air vent which was handy here in South Texas. My least favorite thing, ALL the crappy terrible fragile plastic! I never could get rid of all the rattles though I tried mightily.
I was able to outdrive many a guy in their 5.0 Mustangs of the day, only because of the turbo and that I had some racing experience most guys didn’t have. Otherwise the Mustang could be the faster car. The torque steer in the car was unbelievable bad! The adjustable suspension was nearly a joke, barely any discernable difference between settings. Oh, and the junky Mistsubishi built alternator destroyed my expensive stereo system when the alternator blew.
Thanks for sharing and the fact that you loved these cars too. Almost all of them are gone now.
I forgot to add, I just stumbled upon your channel yesterday and enjoy your relaxed and unpolished style. Especially enjoying your LS swap series. I am happily bingeing!!
Question have you ever had to replace the rubber O Ring in the water pipe?
Hi Eric, Thanks for sharing this video. I have this MAZDA 626, 1989. I regret leaving this car in the driveway baking under the sun and snow in winter for years, this was my backup car. But this time, I want to use it again.
Do you have the parts that I need for this car, HAZARD SWITCH & ECO SWITCH? They just fell off, I think due to the heat and cold exposure. And also I need the driver-SIDE MIRROR so with the PASSENGER SUN VISOR.
I can pay for the shipping for all of these parts.
Thank you and I hope you will respond to me. More Power to your Channel!
My a/c blower not working do u have 1 91 mx 6
Thanks for the video. Just wondering if you think the LX can upgrade the heater controls from a GT model. I plan on going to a u pull it, in a week or so because they have a 91 model, and I want the grill from it. I prefer the 90-92 grill more that the 88-89. I realize I would also have to grab the motors to what the heater controls go to. But not sure if it will bolt up and also have the electrical connectors.
Mike P you’ll need the entire dash harness, and the body harness to do it right.
@@I_Do_Cars Thanks, I really don't want to swap out a harness. It would have to be plug and play.
Ese coche tiene obd ? Tengo uno igual
Do you have a mumper for a 91 maxda mx6
This helped me alot!
@I do cars I'm interested in the drivers side window switches if available!!! Also the rear defrost switch assembly.
If you happen to have the manual climate control that works in a 90 mx6 non-turbo, I'd be interested in that too.
Chris Dowing not sure if I have the manual climate control but I do have the switches you asked about. Email me at Mazdamiester@gmail.com and we’ll go from there
Do you have a Blue dash for sale?
Good day can this dashboard work in the 626 coupè
88-92 yes
I am looking for front and rear working AAS struts,
Unfortunately I don't think i've got any that I would trust. They're almost all gone anymore.
You still got any any parts?
Hi there, i am looking for a set of side markers for the front bumper and a set of US spec taillights (with the red blinkers instead of orange) do you have any available? I have 1989 626 coupe/mx6 located in The Netherlands.
TheMarkitos81 I have all of those parts. Do you need the center taillight panel to match?
@@I_Do_Cars Thats awsome. I am not sure if the center panel will fit. because of the diffirent sice of numberplate we have in Holland. but i can give it a try.
TheMarkitos81 measure your plate and let me know. I have a set of all red 90-92 style. Shipping the center piece will be a little pricey but totally doable.
@@I_Do_Cars standard size is 520 x 110 mm. Might be able to change it to 340 x 210 mm. are the reversing lights in the centre panel? And what will the whole lot cost?
TheMarkitos81 let me get a quote and I’ll get back with you!
Could I get the injectors?
Any chance you still have any parts from this guy? 😁
I own a 91 mx6 I’m trying to restore it for fun
Where would I find the blower motor resistor coil
Im trying to find a burgundy MX-6 soooo bad specifically a 91 non gt model. Good luck with the restoration though!!
Parts store, AutoZone etc has them
Gracias por el video me fue súper útil
thanks for this
Hey are you able to sell parts off of the Madza in the video? And if you're able to, can you sell me the left and right wheel spindell knuckles, the door handles, and window motors?
Sure! Still have all of those parts. Email me at mazdamiester@gmail.com
I MISS my MX6!!!
Ford Probe was the same car, different body. I had an 89 Probe. Ultimately got rid of it for the same reason, too much rust.
If you have tha sunroof and if it works i want it
I need quite a few parts. Especially red interior bits
Feel free to email me at Juslisn2me@aol.com, or find me on facebook.
@@I_Do_Cars Facebook name? Couldn't find ya
Ahhh The good ole days of SIMPLICITY!
I wish I could find some parts for one I just got
What do you need?
@@I_Do_Cars I need a dash a headliner both sunvisers a dome light a passenger side turn signal light and the little black plastic cover that covers the bolts for the passenger side door mirror on the inside my car is a 90 gt turbo sunroof car
@@williamdraughnchannel603 As far as sun visors go. On my 626 without sunroof I pulled some off a mazda millenia, not sure if they will fit with sunroof. For my MX-6 with sunroof, I got a couple from a Volvo v40 or s40 not sure what year, but is wasn't the earlier one jointly made with Mitsubishi. Not the best fit, I could only get one screw in. But they work. I had a Miata and they bolt up pretty good. But much thinner. I went to a U pull it to get these parts.
@@mikep4866 I found a 626 at a pull-a-part I got the dash the dome light and sunvisers I had to cut the sunvisers to make them work
Still have any parts?
Some. Whatcha need?
@@I_Do_Cars do you have the front signal markers? And the grill piece and the visors
That was back in the day when Mazda made decent vehicles.
I had an 88 mx6. I loved that car and got 245k miles out of it. I seized it do to an electrical issue. Put a replacement engine in and crashed it into a tree.