When I plug in the control board to my computer via USB, it still says device not detected. I have the actuator correctly plugged in, and a 12 Volt battery pack wired to the board. I followed everything exactly and still cannot get it to work. Can y'all please tell me what I did wrong?
Hi there. For support with your LAC board, you can contact us through the contact page on our site. Unfortunately, though we have limited arduino resources on our site and on RUclips, we don't officially offer arduino code support.
Hi, use terminal 3 (RC) of connector block X6 for your signal in from your Arduino board, and make sure your LAC and Arduino boards have a common ground. Then you can use the Arduino servo library to drive the LAC and actuator connected to it.
Hello, sorry the LAC is not compatible with a Sabertooth, however you can run any of our "S" series actuators with a Sabertooth as they use reversing polarity.
When I plug in the control board to my computer via USB, it still says device not detected. I have the actuator correctly plugged in, and a 12 Volt battery pack wired to the board. I followed everything exactly and still cannot get it to work. Can y'all please tell me what I did wrong?
I'm looking forward to the next video. I need help with LAC card connections and how can ı use this with arduino
Hi there. For support with your LAC board, you can contact us through the contact page on our site. Unfortunately, though we have limited arduino resources on our site and on RUclips, we don't officially offer arduino code support.
I agree with Hilal. Would be nice to know how exactly it interfaces with arduino. No code support necessary.
James Otis There are more descriptive examples in Arduino.cc site. I recommend you take a look.
Hi, use terminal 3 (RC) of connector block X6 for your signal in from your Arduino board, and make sure your LAC and Arduino boards have a common ground. Then you can use the Arduino servo library to drive the LAC and actuator connected to it.
Thank you so much!
I want total code linear actuator motor interfacing with 8051 and its possition save, pls help.....
Hello sorry I have no idea what you are asking.
Does this work with the P8 micro actuator?
No it does not. You need a stepper driver board like the TIC825 from Pololu
We have now released a P8-P model which does work with this board.
very very nice......
compatible with sabertooth ??????
Hello, sorry the LAC is not compatible with a Sabertooth, however you can run any of our "S" series actuators with a Sabertooth as they use reversing polarity.
thank you very much
Why is it so big?
I guess that depends what you compare it to.