Calibration of Honeywell Sensepoint XCD sensor

how to calibrate the Honeywell Sensepoint XCD sensor #H2S #LEL# Calibration #oilrig #onshore #offshore

[@msr4920]

Nice good explain

[@adarshputhiyapurayil40]

Its very informative, expecting more videos

[@vishnuvichu6758]

Thanks for your information sir,
Can you make one calibration video for Gastronic sensors

[@theAestheticMariner]

Sure it will come soon 🔜

[@kalanasulakshana279]

Good ❤

[@supertech9727]

Thank you nice explain and how much this h2s sensor

[@TamilBisayan]

Nice 🙏🏿... I would like to learn from your experience and knowledge regarding all fault errors... How to find out what the exact fault is and how to rectify it ... Can u help me

[@theAestheticMariner]

Sure

[@anandarun326]

Txs bro

[@gunasekharpallala2605]

Nice video brother can u make calibration video for itrans sensor

[@theAestheticMariner]

Yes sure I trans 2 sensor calibration video will come soon

[@thetechfreak4204]

Thanks

[@dayarao1555]

Can you post o2 calibration on xcd

[@nepal_declassified]

Where do you find H2 Span cylinders in india. Can you please provide vendor details.

[@alanfate4853]

Which gas did you use? If I were to use 50% LEL methane (2.5%), should my PPM be 25000?

[@theAestheticMariner]

Am using gulf cryo Gas for the Combustible Gas sensor using 50% LEL methane. Just change the sensor cell

[@alanfate4853]

@@theAestheticMariner how do I do that?

[@lordfizzz]

We set the XCD to 50% lel CH4 or 100ppm for CO. I use 2.5% (50% lel) also

[@tony-10]

Are you using any mask or any safety equipment while calibration

[@theAestheticMariner]

Yes am using n95 mask

[@mohammedmujahid829]

Sir, I need wiring how to connect and start the device

[@theAestheticMariner]

There is only 3 connections + ve -ve signal

[@mohammedmujahid829]

Sir, your WhatsApp number..??

[@theAestheticMariner]

@@mohammedmujahid829 [phone]

[@SachidanandaDhal-n8t]

one of gms have some issue when going for zero calibration i found some value in zero calibration which not going to zero level .Do u have any solution about that

[@theAestheticMariner]

Use the zero gas cylinder for the zero calibration

[@sachidanandadhal9023]

@@theAestheticMariner it going to be -26 when I m going for zero calibration, I am using sensopoint xcd

[@sachidanandadhal9023]

In zero calibration mode it showing - value when I applying gas it going to positive value but return to negative after tht

[@sachidanandadhal9023]

Can u please elaborate the issue & the display showing fault alarm F-03

[@shameersharafudeen4530]

How to rectify communication error

[@Kannanvel78]

Can u pls help me after entering the menu up and down keys are not working

[@theAestheticMariner]

Bro just remove the outer enclosure and try with magnet

[@Kannanvel78]

@@theAestheticMariner yes bro i removed the cover . Enter button is working only up down key button not working

[@theAestheticMariner]

Then you need to change the display unit bro. Try with big magnet

[@MontgomeryAlvis-y2e]

Pacocha Fork