Hello, can you tell me what the torque spec for the rocker shaft bolts is, i've been searching for almost 2h and didn't found anything. Thanks, best of luck.
I’m doing this job, struggling to unclip the wires from the injectors and what’s the torque setting for the rocker shaft? This video by the way is very helpful, many thanks 🙏
Hey up my 2nd injector just went on mine some say it could be to a faulty loom so I have a new one coming tomorrow. If not I’ll buy a injector are these easy to fit or is this a job for a garage cheers
It can take a while depending how long you've had the injectors out as diesel will flow back to the tank.... I used a 2nd battery with jump leads.. crank in 10 second interval and see how you get on
@bazmeredith brilliant thanks they have been out for a couple of weeks, new fuel filter too which I primed with injector cleaner, thanks for the speedy reply, I'll give it a bash again tomorrow with another full battery, cheers
All up and running now after following your vid for setting up new injectors , lumpy idle has now gone , we'll I say lumpy, more like an overloaded washing machine on spin😅 ps I was one tooth out on new timing belt which was causing my crank but no start issue🙈
What was the sympthoms of injectors? I have bad issues about 1.000 /2000 rpm shacking twiching. New VDO egr all rest cleaned no Check lamp. Injectors controled all fine🙆♂️
Same issue as mine engine badly shaking, worse when coming to a stop, I replaced the injectors due to high milage set the lash as in the video , no more shaky engine😄
@@bazmeredith if i were to take injectors out to clean them and put new seals on do i need to put new injector bolts and how many is it 1 or 2 bolts per injector thanks
Hello, can you tell me what the torque spec for the rocker shaft bolts is, i've been searching for almost 2h and didn't found anything. Thanks, best of luck.
I’m doing this job, struggling to unclip the wires from the injectors and what’s the torque setting for the rocker shaft? This video by the way is very helpful, many thanks 🙏
Try using long nose but mus be careful
Fantastic job. Would like you to do this on my car 😊 (same engine)
If you put another injectors in must you adjust your injectors again
Hey up my 2nd injector just went on mine some say it could be to a faulty loom so I have a new one coming tomorrow. If not I’ll buy a injector are these easy to fit or is this a job for a garage cheers
They need to fitted correctly if not you can cause engine damage
Ive got one injector down so can i just replace that one. Do i need todonthe rest of the steps in your video
Just do the one that you are replacing, however it wouldn't hurt to check and adjust them all while your at it
Where do you send your injectors to get rebuilt?
United diesel. In Shrewsbury
How much did it cost you?
Is this Simens injektors ???
Hi if the loom is faulty what symptoms will i get and can a bad loom cause glow plug p0674 code thanks
How long dis it take to start after as I'm having issues flattened a fully charged battery, is there any starting procedure you Need to follow?
Thanks
It can take a while depending how long you've had the injectors out as diesel will flow back to the tank.... I used a 2nd battery with jump leads.. crank in 10 second interval and see how you get on
@bazmeredith brilliant thanks they have been out for a couple of weeks, new fuel filter too which I primed with injector cleaner, thanks for the speedy reply, I'll give it a bash again tomorrow with another full battery, cheers
All up and running now after following your vid for setting up new injectors , lumpy idle has now gone , we'll I say lumpy, more like an overloaded washing machine on spin😅 ps I was one tooth out on new timing belt which was causing my crank but no start issue🙈
What was the sympthoms of injectors? I have bad issues about 1.000 /2000 rpm shacking twiching. New VDO egr all rest cleaned no Check lamp. Injectors controled all fine🙆♂️
Same issue as mine engine badly shaking, worse when coming to a stop, I replaced the injectors due to high milage set the lash as in the video , no more shaky engine😄
Hi to remove the injector loom do you have to remove the metal clip on the head loom or not thanks
Not sure what Clio you mean
@@bazmeredith on the injector loom the head loom the round part on the head has a metal clip does that need removing to remove the loom thanks
Where the rocker shaft is next to it the cam side there are little pins dose anyone know what they are called I need two of them
Hi i have same car how many hour labour will garage charge to clean injectors and put new seals thanks remove and put back in
2 hours is to remove and refit
@@bazmeredith thank you
@@bazmerediththanks man. I was quoted 400+€ for c6 bre injector seal replacement wth😂 never going back to that workshop.
Hi how many bolts do i need for these injectors thanks
In what respect
@@bazmeredith if i were to take injectors out to clean them and put new seals on do i need to put new injector bolts and how many is it 1 or 2 bolts per injector thanks
2 bolts per injector - they're 'stretch bolts' and have a tendency to snap if reused.
😳