Installing a DIP magazine release on a CZ 457 .22LR rifle
HTML-код
- Опубликовано: 10 сен 2024
- Get your own DIP CZ magazine release upgrade here: www.diproducts...
Follow me on IG : @ZackCarlson_Writer / zackcarlson_writer
Support me by buying anything from Brownells, they support me so please support them. Click here: bit.ly/2Im76hO
Support the channel by buying something from PSA: bit.ly/2TQqche
Or lastly buy anything from Amazon, and I'll get a small percentage. : amzn.to/2XzEHII
Disclosure: Some of the links in this post are affiliate links and if you go through them to make a purchase I will earn a commission. You will not pay any more for going through my links. I link these companies and their products because of their quality and not because of the commission I receive from your purchases. The decision is yours, and whether or not you decide to buy something is completely up to you.
Just an important point here: On the rear screw holding the magazine well to the receiver, if you remove this screw completely, you will be detaching the bolt guide which sits inside the receiver from the receiver. To reinstall the bolt guide is pretty tricky because it has great cross threading potential as the bolt guide, receiver, and screw have to be aligned exactly. It took me an hour to get this done. I finally used a recovery magnet to reach into the back of the receiver to hold the bolt guide in place while feeling for that first thread to match the bolt guide. Wiggling the magnet allows so you can get it just right.
I just installed the AO extended mag release with your video. Thanks for mentioning the exact bit sizes to use. Screwdriver trick was helpful too!
Just wanted to comment on really well done videos. You explain each step very well and the tips are useful without droning on too much.
Thanks, I try to be straight and to the point.
Bought one for my 455 trainer from Anarchy. The hole was to small for the spring. Had to drill out. Other then that was easy to install. It makes it easier to change mags. Also picked up a extended bolt handle from Glades Armory. Their bolt allows you to keep your scope close to the barrel. So much easier on the fingers.
Beautiful gun I have the same setup but a 8x32x56 Athlon.
Can you tell me about that bipod mount? Just received my AT-ONE and I'm having trouble figuring out the best rail option with only the factory sling mount present
Oh - and thanks for the info on the extended release!
What is that plastic piece in the mag well? Is there a metal replacement for the mag well housing?
Try the Yo Dave trigger spring to lower the pull pressure. It has worked well for me. Thanks for the info.
I have one incoming. Should be here this week!
Can`t you just install the mag in it to do all your holding for you while you install the pin back in it?
Great Video, What brand and size scope base and rings does your rifle have?
Did you glassbed your action-stock ?
I did not
Excellent, a fix to a non existent problem.
Your non-existent problem is someone else's perfect solution, gotta keep your mind open.
Ok boomer...🙄
I can’t imagine myself resting the gun upside down on the scope.
If you don’t trust your optic in that limited use it’s probably not that good of an optic.
Get a decent optic then...
Fixing problems that aren't problems.
Thanks for watching