It is a necessary to draw strip for different slabs differently or is it advisable to draw a strip along two or more slabs of same starting and ending type (slab to slab or Bob to Bob)
Thanks for this mate, highly appreciated! One thing though, how would you do a section detail through the slab with rebar? Orion would do it nicely, but Prota would only do a section without showing any rebar details. I tried it exporting into ProtaDetails as well, but no luck! Am I doing it wrongly? Please advise?
But why sometimes if you make strip for whole slab shows everything pass (section is sufficient) but when you make srtips for individual slab(one panel to the other) show some panels has insufficient section,please help why is this happening?
![[DOKKAN BATTLE] Worldwide Campaign Announcement Video Part 2!](http://i.ytimg.com/vi/JpT5Voak6WA/mqdefault.jpg)
It is a necessary to draw strip for different slabs differently or is it advisable to draw a strip along two or more slabs of same starting and ending type (slab to slab or Bob to Bob)
ขอบคุณครับ
Thanks for this mate, highly appreciated!
One thing though, how would you do a section detail through the slab with rebar?
Orion would do it nicely, but Prota would only do a section without showing any rebar details. I tried it exporting into ProtaDetails as well, but no luck! Am I doing it wrongly? Please advise?
I would like to know too...
already have the answer ?
Hi how are you doing
I have been following your posts
Thanks very much for the lesson
I want to find how do I add a slab overhang
Hi sir could u tell us how to design simply supported slab that rests on the masonry walls in protastructure.?
Pls what's the different between FE and anayltical and when to use each
Hello Sir, could you tell me about system you design in video ?
Thanks so much
Engineer goodday..I wanted to find out if I make strip under analytical does it mean it does not need to under go FE slab analysis...pls
Strip is provided to get proper drawing depending on governing moment on that strips. FE analysis is needed to proper load distribution calculation.
But why sometimes if you make strip for whole slab shows everything pass (section is sufficient) but when you make srtips for individual slab(one panel to the other) show some panels has insufficient section,please help why is this happening?
tanks decode
WELCOME DEAR.
@@Decodebd reply on MrZakmuh question please sir